Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81393
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF30 | NO HORIZONTAL SYNC IN CAMERA POSITION | No horizontal sync in camera position. | ||
| Sony | GV8 | NOISY WHEN BREAKING | Noisy when breaking. Take-up-table gear teeth were worn out. | ||
| Sony | GV8 | NO VIDEO OUT FROM LINE | No video out, when line input is used, pin No. 8 on IC-701 isdead. | ||
| Sony | CDXR7 | COVER WILL NOT SNAP ONTO FRAME/MISSING INDENTATIONS | Cover (3-323-287-01) will not stay snapped onto frame(3-323-218-01). Frame does not have indentations like original to acceptand hold cover. -HQ COMMENTS: I am checking with Tokyo to see if there were two chassisand covers. | ||
| Sony | CDXA20 | D-509 WRONG ON NEW MCB JACK | CDX-A20 in for smashed MCB Jack and back. Replaced MCB andback. Noticed elevator ran slow. | ||
| Sony | EVS1 | UNIT ACCEPTS NO COMMANDS | Unit powers up but accepts no commands. FR-27 and TS-64circuit boards corroded. | ||
| Sony | KV1380R | NO PICTURE/WHITE LINES AT THE BOTTOM OF THE PICTURE, R552 | No picture, high voltage ok - white lines at the bottom ofthe picture. | ||
| Sony | SLV70HF | NO DRUM ROTATION | Unit loads tape capstan turns, but the drum does not. Thetape is then brought to the half loaded position and all commands aredisabled except eject. | ||
| Sony | TAAX285 | DEAD AMP | Fuse 1 blown no power. Replaced fuse had power but no audio.Found emitters of Q-511, Q-512 had 55 volts on them - and were shortedfrom emitter to base. | ||
| Sony | CFS212 | INCORRECT PART NUMBER IN SERVICE MANUAL | Part number in service manual (page 13, reference No. 5)X-3344-323-1, is incorrect. | ||
| Sony | UP811 | MULTIPLE PICTURE (REPEATS HORIZONTALLY) | The unit prints about the first 1/3 of the picture insuccession from left to right - creating a tripple image effect. | ||
| Sony | D15 | NO CHARGE OF BATTERY | Battery would not charge. Charging circuit inoperative.Found R-403 incorrectly located on the board and soldered to the collectorof Q-433. | ||
| Sony | CPD1303 | VERTICAL FOLD AT TOP OF SCREEN | Vertical fold at top of screen. 80 volt measured on 15 volts.T-654 secondary open. | ||
| Sony | CPD1302 | VERTICAL FOLD AT TOP OF SCREEN | Vertical fold at top of screen. 80 volt measured on 15 volts.T-654 secondary open. | ||
| Sony | CCDV220 | INTERMITTENT VIDEO DROPOUT | Intermittent dropout in playback picture. |