Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CPD1303 | RECOMMENDED SCREEN CLEANER | |||
Sony | CPD1303 | CURVATURE OF THE CRT | What is the curvature of the CRT? -HQ COMMENTS: Radius of the curvature for the CRT is: Side to sideR = 660mm. Top to bottom = flat (infinity). Corner to corner R = 1015mm. | ||
Sony | CPD1303 | MISSING PART NUMBER ON SERVICE MANUAL | The mounting screws for the 9 pin (d type) connector arespecified as part number 768564679. This is the correct mountingscrew for the AC Connector but not for the 9 pin connector. The screwneeded is shown on page 45 of the service manual. It is the sc | ||
Sony | CPD1303 | SHUTDOWN AFTER WARMUP | Ohm meter check between HVR and GND measures 100K - 120K Ohms:too high. Both part numbers above sub to 1-230-666-21, which normallymeasure 100K ohms or slightly less: ok. | ||
Sony | CPD1303 | VERTICAL FOLD AT TOP OF SCREEN | Vertical fold at top of screen. 80 volt measured on 15 volts.T-654 secondary open. | ||
Sony | CPD1303 | FLAGGING AT TOP OF SCREEN WHEN USED WITH MAC II | After about one hour of operation, a flagging would start attop of screen when used with MAC II. This problem would not be seen withmultiscan generator at Macintosh II frequency. | ||
Sony | CPD1303 | SLIGHT BEND IN VERTICAL LINES | Very slight bend in vertical lines at top one inch of screen.I was suggested that I try to modify AFC circuit to resolve complaint. | ||
Sony | CPD1303 | STATIC SHOCK | 1) Static shocks when touching chassis/screen 2) A spark ofstatic when removing screws of the back cover -HQ COMMENTS: We found the static at CRT surface exist only when the setis turned off. However when the set is on, there is no static on thescreen |