Dicas Reparação
Modelo - Chassis CPD1302
Pesquisa: CPD1302 Enviar Dica Resolvida
Resultados 22
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CPD1302 | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
| Sony | CPD1302 | RECOMMENDED SCREEN CLEANER | |||
| Sony | CPD1302 | RECOMMENDED SCREEN CLEANER/USE (3-731-449-01) DRY SOFT CLOTH | |||
| Sony | CPD1302 | SHUTS DOWN IMMEDIATELY WHEN RGB CABLE IS CONNECTED TO PC | The unit would shut down immediately after the cable wasconnected to the computer. | ||
| Sony | CPD1302 | ON WHITE BACKGROUND LETTERS HAVE BLACK TAILS (STREAKS) | On a white background letters have black tails (streaks). | ||
| Sony | CPD1302 | NO PINCUSHION CORRECTION | No pincushion correction. | ||
| Sony | CPD1302 | AFTER WARM-UP, HIGH PITCH TONE | After a warm-up period of 15 to 30 minutes, internal noisewould be generated (1kHz range). Using an isolated tool, and touchingT-653 the noise would stop and then return. | ||
| Sony | CPD1302 | VERTICAL SYNC PROBLEM | Unit came from independent service shop, they replaced IC-301on BA Brd and IC-206 on BD Brd. The vertical sync problem was notsolved (since they could not identify problem, unit was sent to us).Checked vertical sync at pin 9 on IC-206, ok. Checked pin | ||
| Sony | CPD1302 | CURVATURE OF CRT | What is the radius of curvature for the CRT? -HQ COMMENTS: Side to side R = 660mm. Top to Bottom = flat (infinity).Diagonally R = 1015mm. | ||
| Sony | CPD1302 | SCREEN OSCILLATES | AC Power lead from the ON/OFF power switch was dressed acrossthe CRT neck at gun. This introduced 60 cycle hum in picture. | ||
| Sony | CPD1302 | BAD PURITY | Two problems noted - thermistor shorts - blows fuse.Thermistor overheats - melts solder where mounted to board causing openconnection. | ||
| Sony | CPD1302 | SHUTDOWN | Set would shutdown immediately at turn on. Pin 6 of IC-301measures approximately 12 volts. | ||
| Sony | CPD1302 | PICTURE BLANKS IN DIGITAL MODE | Monitor works fine when the ANALOG/DIGITAL switch located onthe rear panel of the unit is set to ANALOG. But, when the switch is setto DIGITAL the screen will blank. | ||
| Sony | CPD1302 | VERTICAL BOUNCING | Picture is unstable in all modes of operation. Also, the80 volt line measures high. | ||
| Sony | CPD1302 | HI V SHUT DOWN WHEN COMPUTER TURNED ON. | Unit would shut down whenever computer connected to it wasturned on. Worked O.K. after powering monitor down and up again. |