Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | GV8 | NO VIDEO OUTPUT | No video output. IC701 pin2 had video input but no video at pin 8 of IC701. No sync at pin 14 of IC701. | ||
Sony | GV8 | LCD ON/OFF BUTTON PART NUMBER | According to FPR O0310 this button is part of the Upper SCcabinet assy REF#51 (X-3726-857-1) but it is not. HQ COMMENTS: The button is available separately under part number3-728-953-03. | ||
Sony | GV8 | FP-142 FLEX CABLE | From page 126 of service manual, ref# 165 is shown withconnector attached. Part # 1-628-034-11 received twice with no connectorattached. Service needs part as shown, with connector attached. -HQ COMMENTS: These parts must be ordered separately. Part n | ||
Sony | GV8 | NO ON SCREEN DISPLAY/CHECK FP-133 FLEX/30V LINE | No on screen display. Could not determine why it was notworking. | ||
Sony | GV8 | WRONG SUBSTITUTE FOR IC101 (SV-34) | When the above part number is keyed in the parts system, itsubstitutes to 8-752-809-34, which is a CXP5058H-200Q. Is this a goodpart substitution? RPC gives us the same sub number. The servicer claimsthe new IC does not work. Can you please advise? | ||
Sony | GV8 | WILL NOT EJECT | When the eject mechanism unloads halfway, unit stops.Troubleshoot mechanism, no fault found. Checked pulse for off sensor, nopulse. Measured for 5V on pin 2 of CN-006 of SV-34 board, found 5Vmissing. Checked voltage around Q-112, found emitter of Q-11 | ||
Sony | GV8 | DISTORTED VIDEO DURING PLAYBACK | Distorted video playback. Record was fine. Appeared tobe loosing sync partially and tearing in picture. | ||
Sony | GV8 | NO EJECT | Unit would not eject.Motors would not run. Found F-101 andF-104 open on (PS-181) board. Replaced fuses and unit would still noteject. Loading and capstan motors would run in an attempt to eject, butcassette compartment would not release. I found that | ||
Sony | GV8 | PART NUMBER | Need part number as soon as possible for the mode switch. -HQ COMMENTS: This is in the CCD-V99 service manual on page 179. Thepart number is 1-571-664-11. | ||
Sony | GV8 | PART (WINDOW SC) NOT INCLUDED WITH CABINET (SC) ASSEMBLY | Customer ordered new cabinet part (Ref. No. 51) for GV-8. Notincluded was the screen, although the manual shows the screen should beincluded in the assembly. -HQ COMMENTS: Part number for screen is 3-728-933-13. | ||
Sony | GV8 | RECORD KNOB | Record knob is not available. It is necessary to order entirepanel items yet the power knob, which is almost the same is available,items 12 and 10. | ||
Sony | GV8 | IS THE VCVGV8 GLASS OR PLASTIC | Is the VCVGV8 (sunshade) glass or plastic? | ||
Sony | GV8 | ANTENNA DISTRIBUTOR PART NUMBER | I need the part number for the antenna distributor with themini-plug for the GV-8. -HQ COMMENTS: The part number is 1-417-173-11 | ||
Sony | GV8 | IS RECORD SWITCH AVAILABLE AS A REPLACEMENT PART | Is the Record Switch available as a replacement part? -HQ COMMENTS: No, the entire cabinet must be replaced. | ||
Sony | GV8 | BATTERY RELEASE BUTTON PART NUMBER | What is the part number of the battery release button on theGV-8? -HQ COMMENTS: The part number is 3-728-948-11. |