Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81392
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDTR81 | INTERMITTENT PLAY - SHUTDOWN IN REWIND/RELAY BELT REF 367 | Unit would play for a short time and shutdown. Shutdown inRewind occasionally eats tapes. | ||
| Sony | CCDTR1000 | OWNER'S MANUAL FOR CCD-TR1000/SAME AS CCD-TR101 | |||
| Sony | CCDTR101 | UNIT WILL NOT EDIT SEARCH/DEFECTIVE SWITCH BLOCK | Edit + and - both would cause tape to roll. However, videowould be muted. Suspect faulty matrix. | ||
| Sony | CCDV801 | CIRCUIT BOARDS ARE DIFFERENT/SM SUPP-2 | |||
| Sony | HSTV102 | NEED MOTOR MOUNT PART NUMBER | Part number for motor mount shown on page 28, shown as notsupplied. Part got thrown out with old motor. -HQ COMMENTS: We have contacted Tokyo and they have agreed to send onepiece for the repair of this unit. We will inform you once we receive it.4/22 | ||
| Sony | KV32XBR15 | BAD PINCUSHION, Q-505 GETS HOT, REPLACED L501 | Servicer had problem with pincushion. Replaced R-571, Q-505and D-512. checked L-501 and thought it was ok. It read about 2 Ohms andit should be approximately 4.5 Ohms. I suggest a service bulletin beissued concerning the above. -HQ COMMENTS: Please | ||
| Sony | PVM1271Q | PICTURE HAD SEVERE PINCUSHION | Monitor had a severe pincushion problem and was expandedhorizontally. Pin and horizontal controls had no effect. Traced problemto pincushion transistor Q-806. Voltage at the collector of Q806 was 3.4volts, not 35.1 volts as stated in the service manua | ||
| Sony | CDPC325 | INTERMITTENTLY WILL NOT TURN ON | Unit intermittently will not power up. | ||
| Sony | CCDFX511 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the mode select switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
| Sony | CCDFX510 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
| Sony | CCDFX411 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the mode select switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
| Sony | CCDFX410 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
| Sony | CCDFX310 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
| Sony | GEN-HFP | TIPS ON REMOVING 94 PIN FLAT PACK IC'S OR LARGER | Removing 94 pin flat pack ICs or larger. Example: IC-701TADM1000ES do not have the right Hozan tip to fit. | ||
| Sony | TADM1000ES | NO SIRCS OUTPUT ON VIDEO ONE - IC701 (P/N 8-759-152-23) | No SIRCS output to video one or video two but other SIRCSoutputs are fine. |