Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDFX510 | INTERMITTENT COLOR/ X301- VA-74BD | Received a few reports of intermittent color. Problemoften goes away if case or board are slightly stressed. Problem causedby intermittent color crystal, X301 on VA74 board. When in failure modefrequency of operation is around 5 mhz. Replacing re | ||
Sony | CCDFX510 | NO COLOR IN PLAYBACK/IC301-VA74 PIN 14 RESOLDER | No color in playback. | ||
Sony | CCDFX510 | CHARACTERS ROLL IN V/F (VTR MODE ONLY) - D205/VA BD | Problem with unit was that the characters would roll in theviewfinder in vtr, only in a stop condition (not during play). In cameramode everything was ok. After finding a loose diode in the mech, I startedlooking for where it came from. Luckily it wa | ||
Sony | CCDFX510 | PREMATURE TAPE END DETECTION | We need clarification on CSV-3 Service Bulletin #333. The partlisted as C865 is a filter cap on the focus motor B+ line on p.116. Thedrawing in the S/B shows C559, which is a filter on 5V regulator IC508 onp.122. Which cap should be changed for this symp | ||
Sony | CCDFX510 | PICTURE ROLLS IN EVF/ RESOLDER CN905 | Picture jumping or rolling in viewfinder when unit is slightlymoved. | ||
Sony | CCDFX510 | LOSES MEMORY WHEN REMOVING MAIN BATTERY/CHECK C891 | When the main battery was in camera, LCD flashed as if nolithium battery was installed, but had date and time. If main battery wasremoved, memory would be lost. | ||
Sony | CCDFX510 | NO E TO E VIDEO/REPLACE IC709 | No E to E video. Some noise in viewfinder. | ||
Sony | CCDFX510 | PART NUMBER FOR IRIS ASSEMBLY/USE 3-708-486-01 | Iris assembly is easy to change, but not available. You haveto replace the entire lens. Iris assembly can be removed by 1 screw. | ||
Sony | CCDFX510 | DATE TIME INDICATES BAD LI BATT/CHECK IC507 | Traced Li 3 volt on page 69 and 70 of Service Manual from Pin1 CN575 to Pin 10 W570 of UM27 board to pin 6 of the CS 35 board to Pin4 of IC507. Found bad connection at IC507. | ||
Sony | CCDFX510 | ORDERED (ARM T) ASSY, GUIDE RECEIVED (ARM S)ASSY GUIDE | Upon repair of CCDFX510 R#209 is needed. But I receivedR#230 in parts bag. So, I ordered both parts X39412671 and X39412661 andreceived R#209 in both bags. Enclosed are the unopened bags. -HQ COMMENTS: Kansas City checked their stock and fixed the p | ||
Sony | CCDFX510 | WRONG P/N FOR FP-558/CORRECT NUMBER IS 1-643-555-11 | Item 107 on page 153 of service manual has the wrong partnumber, when ordering 1-645-271-11, the flex connector is only about oneinch long. The original flex connector is about 4 1/2 inches long. Inaddition, on page 87 it's described as FP558. | ||
Sony | CCDFX510 | AVAILABILITY OF FP-443 BOARD | What is the part number for the FP-443 flex board? -HQ COMMENTS: This part is not available separately. It is supplied withthe LS Chassis Assy (X-3941-265-1). | ||
Sony | CCDFX510 | NO COLOR IN PLAYBACK/ D529 | There was no color on playback, C310 knocked off VA74 board. | ||
Sony | CCDFX510 | UNIT IS INTERMITTENTLY DEAD OR HAS NO FUNCTIONS/W651 | The unit is intermittently dead after assembly during repair.I found you can flex W573 or W561 to introduce the problem. The cable isbreaking at the end that plugs into the CS-35 board. | ||
Sony | CCDFX510 | NO COLOR IN PLAYBACK, CAMERA VIDEO OKAY/LEAKY C310, VA-74 | No playback chroma. The camera video was okay when monitoredat video out. |