Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81412
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDX600DSP | STATIC/POPPING IN AUDIO (FOUND DSP IC301 DEFECTIVE) | After unit is on, after a short period of time static can beheard or popping sound from speakers and line outputs. Unit only had themon rear channels L/R. By cooling off IC301, popping sound would stop, andheating up IC301 momentarilly would cause the | ||
| Sony | CDX5040 | NO DISPLAY/NO FUNCTIONS EXCEPT DISC LOAD | No display, no functions (it will load a disc, but it will notplay it). | ||
| Sony | CDX45RF | COMPRESSION SPRING MISSING | Mechanism jammed and discs are stuck inside. Found that thecompression spring (ref. 61) was not in the unit. | ||
| Sony | CDX4050 | NO AUDIO OUTPUT (FOUND COLD SOLDER JOINTS IC701 PINS 29, 30) | No audio output. | ||
| Sony | CCDV5000 | INTERMITTENT COLOR ON RECORDING/ REPLACE C630 | Intermittently no color on recordings, E-E and playback are OK. Found defective filter capacitor C630 in chroma processor. | ||
| Sony | CCDTR81 | PICTURE JUMPS - DC-DC CONVERTER | Picture jumps in playback or camera modes and no output from S video. Discovered no -3.6V (VEE) on video in/out switching transistors Q308, Q309. SOLUTION: Replace DC-DC converter. | ||
| Sony | CCDTR77 | ZEROS IN EVF AND ALL SEGMENTS LIT IN LCD - W501 PIN 14/CN74 | The EVF only showed zeros and all segments and characters onthe LCD were turned on. There was no data to slave signal between LC45and VS103 boards.-SOLUTIOIN :Resoldered pin 14 of W501 on CN74 board. Submitted by DewayneKemp of Entertainment Technolog | ||
| Sony | CCDTR700 | WILL NOT PLAY HI-8 RECORDING/ RESOLDER SL-37 BD | Unit would not recognize Hi-8 tapes, therfore any Hi-8 recording appeared washed out. | ||
| Sony | CCDTR7 | NO COLOR WITH SELF RECORDED TAPE PB / Q508-VC80 BD | Pre recorded PB color ok, E-E color ok only problem no colorwith self recorded tape PB. | ||
| Sony | CCDTR400 | MOTORS NOT WORKING (LOADING, CAPSTAN) F451 OPEN / BAD CN901 | Motors not working (loading capstan) F451 open. | ||
| Sony | CCDTR400 | BATTERY DOWN ADJUSTMENT - CORRECTION | The battery down adjustment in the manual is incorrect. -HQ COMMENTS: Working on a solution. | ||
| Sony | CCDTR21 | IN RECORD LENS COVER INDICATOR IS ON BUT LENS COVER OPEN | When trying to record, the lens cover indicator is acitivatedbut the lens cover is open. -FOUND: S002 is not completely activated. Replaced S002. | ||
| Sony | CCDTR200 | DEW INDICATOR ALWAYS ON / FP573 FAILURE | Dew indicator was activated. Traced to open connector at theedge of the dew sensor element, where it connects to the flexible board FP573. NOTE: This failure happens to both CCDTR200 and CCDTR500. Maybeothers too. | ||
| Sony | CCDFX530 | NO CAMERA VIDEO / BROKEN TRACE ON FP-46 | Unit had no camera video. | ||
| Sony | CCDFX420 | CAMERA VIDEO HAS DIGITAL NOISE / REPLACE CORE IC707 | When in camera mode, the picture looked like it has digitalnoise in video out, but the video looked good in the view finder. AlsoVTR play back on prerecorded tapes looked fine on video out. |