Dicas Reparação




Modelo - Chassis CCDTR400


Pesquisa: CCDTR400 Enviar Dica Resolvida
Resultados 17
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCCDTR400
INT. DEAD, SHUT DOWN, LOCKUP (FOUND BAD SOLDER ON CN203) An ASC reported that the unit had intermittent functions, orwould shutdown or lock up. Problem was found to be caused by poor solderon CN203.
SonyCCDTR400
DRUM SPINS FAST (FOUND X502 BAD) Drum spins fast.
SonyCCDTR400
BATTERY END ADJUSTMENT DATA ADDRESS IS INCORRECT IN S/M When setting up to read data for battery end adjustment,value at address 47 does not change per procedure on page 7-62 of servicemanual.
SonyCCDTR400
NO COLOR ON RECORD OR PLAYBACK / REPLACE X201 Camera had no color through the monitor, but pix in EVF wasOK. Discovered frequency of VXO 40 Hz lower.
SonyCCDTR400
SQUEAL USING MAXELL TAPE / Had a few reports of the CCDTR400 producing a squeal,sometimes intermittently, from drum are which is actually caused by thetape. The offending tape is a Mexell Hi8 XR metal 100. Using any otheretape eliminates the noise. Suspect tape develops a bi
SonyCCDTR400
INT B/W IN PLAYBACK / REPL IC201 (Y/C PROCESS) VS BOARD Pix in playback has weak color and goes to b/w, then back toweak color.
SonyCCDTR400
INDIVIDUAL MOTOR TESTING USING RM-95 Models such as the CCDTR400 and CCDFX430 do not include themotor test on one of the service procedures, ex, capstan forward andreverse drum forward and reverse etc.
SonyCCDTR400
UNIT PLAYS WITH NO TAPE INSIDE / RPL PS500 Unit goes into play with no tape inside also does not sensereel rotation. Found PS500 open
SonyCCDTR400
NO VIDEO FROM IO JACKS / CAB. KNOCKING PARTS OFF BOARD VS104 No video from IO Jacko on camcorder.
SonyCCDTR400
MOTORS NOT WORKING (LOADING, CAPSTAN) F451 OPEN / BAD CN901 Motors not working (loading capstan) F451 open.
SonyCCDTR400
BATTERY DOWN ADJUSTMENT - CORRECTION The battery down adjustment in the manual is incorrect. -HQ COMMENTS: Working on a solution.
SonyCCDTR400
NO LOADING, TAPE JAMMED IN UNIT REPLACE LOADING GEAR (B) Unit had no loading or unloading. It came in with a tape jammed in it.
SonyCCDTR400
POOR FOCUS/ADJUST FLANGE BACK Poor focus.
SonyCCDTR400
TAPE STUCK, NO FUNCTIONS, BEEPS WHEN TURNED ON/MODE SWITCH Tape stuck, no functions, beeps when turned on.
SonyCCDTR400
WILL NOT LOAD TAPE/RE-SEAT S REEL TABLE S Reel table stuck, re-seated reel in proper position.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads