Dicas Reparação




Modelo - Chassis CDX45RF


Pesquisa: CDX45RF Enviar Dica Resolvida
Resultados 11
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCDX45RF
PART AVAILABILITY: HIDEAWAY/COMMANDERS The manual has no part number for Hideaway units and Wiredcommanders that are defective and cannot be repaired to component level.
SonyCDX45RF
SKIPS WHEN PLAYING OUTER TRACKS (SEE BULLETIN 358R2 FOR FIX) The unit skips when playing the outer (higher number) trackson the disc.
SonyCDX45RF
SKIPS (CLEANED EXCESS GREASE FROK MECHANISM) Skips on outer tracks of disc.
SonyCDX45RF
MAGAZINE WON'T LOCK INTO MAGAZINE AFTER IT HAS BEEN EJECTED The lock lever would stay down after the magazine wasejected. Hence, when you reinserted magazine it would not work.
SonyCDX45RF
COMPRESSION SPRING MISSING Mechanism jammed and discs are stuck inside. Found that thecompression spring (ref. 61) was not in the unit.
SonyCDX45RF
REMOTE COMMANDER AMS BUTTON BROKEN Saw this before but thought was isolated. AMS button brokenfrom inside of remote. Found pins inside of upper case which guide AMSbutton were broken.
SonyCDX45RF
PART # CORRECTION: Q503 (CORRECT PART # IS 8-729-204-10) Found part # for Q503 8-729-240-10, was not in system (FIPM).Looked in semi-conductor replacement handbook and found that the # for2SD1417 is actually 8-729-204-10 (page 700 of 1992 2nd SRM). We had thepart in stock and the unit was repaired.
SonyCDX45RF
INTERMITTENT DISPLAY (RE-SOLDERED J4 ON HIDEAWAY BOARD) Display would intermittently go blank. Found broken solderjoints on hideaway PCB at commander input jack.
SonyCDX45RF
NO DISPLAY No display present on the remote commander. Found J4 to becold soldered.
SonyCDX45RF
CHANGER DOES NOT RESPOND TO RESET SWITCH ON HIDEAWAY UNIT Unit has defective reset with the remote unit being used butworks fine with head unit on test bench. Found J3 to be cold soldered.
SonyCDX45RF
SKIPS CONSTANTLY (RE-SECURE MECHANISM TO RIGHT-SIDE DAMPERS) Skips constantly.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads