Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDX5040 | POPPING DURING MODE CHANGE FM, AM OR CD (REPLACED Q102) | Changing from FM1 or FM2 or AM & CD there would be a loudpop in the rear output. | ||
Sony | CDX5040 | NO DISPLAY/NO FUNCTIONS EXCEPT DISC LOAD | No display, no functions (it will load a disc, but it will notplay it). | ||
Sony | CDX5040 | DOES NOT PLAY DISCS (FOK SIGNAL VOLTAGE ONLY REACHES 1.5V) | The FOK line would only rise to ~ 1.5V. Problem was caused byIC2 (Servo IC) loading it down. | ||
Sony | CDX5040 | SKIPPING WHEN OUTER TRACKS ARE PLAYED | The customer may complain that skipping occurs when outertracks of discs are played. This may occur if the mechanism sub-chassisis bent, which makes it more difficult to maintain proper focus at theouter portions of discs. | ||
Sony | CDX5040 | WON'T PLAY DISC WHEN COLD | Won't read disc when cold. All ok when it is not cold.Replaced pickup but no change. I noticed this problem is addressed in theSonam Technical Activity Report (4/92). Has a solution been found? -HQ COMMENTS: The specific problem mentioned in the acti | ||
Sony | CDX5040 | SWITCHES FROM TUNER TO CD AT RANDOM (REPLACE SW80 ON LED BD) | While playing the radio, the unit reverts to CD operation evenif no CD has been inserted. | ||
Sony | CDX5040 | EJECTS DISC PREMATURELY (UNIT MOUNTED AT 45 DEGREE ANGLE) | This unit is mounted at an approximately 45 degree angle in aconsole on top of the transmission. Intermittently it will eject or nottake a disc. Are there restrictions on the angle of installation? Wouldheat from the transmission cause the unit to eje | ||
Sony | CDX5040 | DOESN'T READ TOC | Unit would load disc, spin but not read TOC. Observed thatlaser was not coming on but focus search was. Tried new FOP and RF amp,but they did not solve problem. | ||
Sony | CDX5040 | NO AUDIO FROM TUNER (JUST HISS), CD AUDIO OK | There was no audio from the tuner (AM and FM). Only hissingnoise was heard. | ||
Sony | CDX5040 | SERVICE MANUAL ADJUSTMENT SECTION ERRORS | The adjustment section of the manual has several errors. Onpage 7 shouldn't spindle height be closer to .95mm than .95cm? Also,instructions for entering the service mode are not given. On pages 8 & 9,the diagrams show the scope connected to ground. I | ||
Sony | CDX5040 | DRAWS A LOT OF CURRENT, POWER AMPLIFIER BOARD DEFECTIVE | Draws a lot of current when unit is turned on. | ||
Sony | CDX5040 | PART NUMBER ADDITION - WALKMAN INPUT DUST COVER | The service manual does not list the part number for theWalkman input jack dust cover. | ||
Sony | CDX5040 | NO OPERATION, TUNER OR CD | No tuner or CD operation. |