Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81403
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF35 | NO PICTURE AFTER A WHILE | Picture began to get dim until no picture at all. | ||
| Sony | SLVP30HF | DISTORTED PICTURE AND SOUND | Severe distortion both sound and picture. Audio sounded likespeed was too fast and picture had horizontal line resembling a picturewhich was severely out of horizontal sync. IC-651, pin 13 had videopresent but no video on pin 12. Pin 10, IC-651 was 0V | ||
| Sony | CCDF35 | DISTORTED VIDEO, NO AUDIO, NO RECORD | Distorted video, no audio, no record. | ||
| Sony | CCDF50 | LCD DISPLAY INOPERATIVE | Could not set date/time or reset counter. | ||
| Sony | SLV70HF | PICTURE ROLLS AND NO COLOR IN PLAYBACK | Picture rolls and no color in playback mode. Traced problemto no sync from IC-701. Found C-701 chip cap bad. | ||
| Sony | MDP200 | LD PICTURE DISTORTED AND CD DOES NOT PLAY | 1. Distorted LD picture. 2. CD does not play. | ||
| Sony | D25 | PART NUMBER INCORRECT Q-409 | Part number of Q-409 is incorrect. The correct part number is8-729-921-85. -HQ COMMENTS: A service bulletin has been written and will be issuedshortly. | ||
| Sony | XR7050 | INCORRECT PART | The part KCP sends is a chip component. The part needed isthe one shown on page 11, column 2, third down - 2SC3900. Is the partnumber listed in the service manual correct or has the parts departmentsomehow mispackaged this part? -HQ COMMENTS: The tran | ||
| Sony | CPD1390 | SHUTDOWN AFTER WARMUP | Ohm meter check between HVR and GND measures 100K - 120K Ohms:too high. Both part numbers above sub to 1-230-666-21, which normallymeasure 100K ohms or slightly less: ok. | ||
| Sony | CPD1303 | SHUTDOWN AFTER WARMUP | Ohm meter check between HVR and GND measures 100K - 120K Ohms:too high. Both part numbers above sub to 1-230-666-21, which normallymeasure 100K ohms or slightly less: ok. | ||
| Sony | SL340 | UNIT INOPERATIVE | Unit inoperative. We found regulator, IC-001, is power supplywith all leads internally open. This is the third time I have been shownan IC like this. I am sending sample for your investigation. | ||
| Sony | CCDF40 | NO SERVO LOCK | No servo lock. A strip or snow keeps running up the screen. | ||
| Sony | SLHF1000 | NO CAPSTAN ROTATION | Lost 5V at pin 14, IC-505 found C-817 shorted. Found coldsolder joint on 5V path at the eyelet left side R-600. | ||
| Sony | CFSD20 | POWER TRANSFORMER | Supplied transformer - same part number, does not fit drilledholes. Drilling an additional hole for primary side allows new trans-former to work. -HQ COMMENTS: I will check with Tokyo and Kansas City Parts to see ifthe part has been changed. | ||
| Sony | CFD60 | FOP | Part number is not in the system. -HQ COMMENTS: Normally, obvious replacement parts such as an FOP areautomatically registered in the system, however, if the part exists in amanual yet does not show up on the system, then it means that no one hasordered |