Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81408
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDTR500 | BATTERY END DETECT/CHANGE PAGE D ADDRESS 03 TO DATA 82 | Complaint: When fully charged battery and AC-V500 are hookedto camera, battery indicator will show 3/4/full charge, should show full. | ||
| Sony | CCDTR5 | INTERMITTENT Y CAMERA/REPLACE C318 | Camera had intermit Y signal video would come and go byflexing board. | ||
| Sony | CCDTR400 | HORIZONTAL LINES CAMERA VIDEO/REPLACE DC-DC CONVERTER | After warmup there are horizontal lines in camera video. -SOLUTION :Replace DD-60. | ||
| Sony | CCDTR31 | J901 BREAKS LOOSE FROM DD48 BOARD | I have seen three units in the past 2 months where J901 brokeloose from the DD48 board. On older units, there used to be two screwssecuring the jack to the board, but on these, there are no screws. Theonly mechanical connection is between board and conta | ||
| Sony | CCDTR30 | NO COLOR PLAYBACK AND DOC PROBLEM | No chroma in playback looks like a DOC problem showingdropouts continuously. IC152 also showed no chroma out. | ||
| Sony | CCDTR101 | CAMERA E TO E SNOWS AND DRUM RUNS TOO FAST/REPLACE DC-DC CON | Camers E to E is snowy and drum runs too fast. | ||
| Sony | CCDSC5 | NO CAMERA VIDEO/REPLACE FL651 | No camera video E - E. | ||
| Sony | CCDFX610 | WRONG P/N FOR FP558 ZOOM SWITCH FLEX BOARD/1-643-555-11 | Service manual shows a 164527111 (FP-575) for the flexibleboard which goes from the Zoom Switch to the CS-44 board. This is not thecorrect part. It should be an FP-558 (164355511). | ||
| Sony | CCDF77 | COLOR STREAKING ON SELF RECORD/REPLACE C309, C317 | Playback of prerecorded tapes fine, self recordings producedBW pix with color streaking. Found C309 and C317 leaking electrolyte andarcing on PCB. | ||
| Sony | CCDF55 | DRUM RUNS VERY SLOWLY, TAPE WILL NOT LOAD/C513 LEAKS | Drum runs slow, tape will not load. | ||
| Sony | CCDF35 | NO COLOR IN CAMERA MODE/C704 LEAKING | No color in camera E to E ok on play back. Found trac eopenand corroded in YC mix circuit between Q617 emitter to C656 due toelectrolyte leakage from C704. Refer to grid J19 on page 102 of svcmanual. | ||
| Sony | PIC1000 | NO SOUND, COLD SOLDER AT MICRO IC-1 | This unit had no sound. The expected high at pin 11 of IC401was missing as was its source at pin 110 of IC1 on the PU-90 board. | ||
| Sony | GDM2038 | INTERMITTENT LOSS OF SYNC | Intermittent vertical sync and hor sync when first turned on.Symptom only showed up on VGA graphics mode. Found IC101 to betemperature sensitive using freeze spray and pyco pen. | ||
| Sony | GDM17SE1 | SHUTS DOWN IMMEDIATELLY. OPEN R639 (72V LINE) ON G-BOARD | At turn on the unit goes into shutdown, the power LED, powersaving LED, and geom LED are blinking. Found the 72V line inoperative.Replacing open R639 corrected the problem. -HQ COMMENTS: Thank you for the great symptom description. These typesof LED fa | ||
| Sony | GDM17SE1 | PICTURE FADES AFTER A WHILE CAUSED BY FAILED C-625, G-BOARD | Monitor had normal picture for a few minutes then, faded outto none. If unit was allowed to cool down then re-powered, the sameoccurred. Checking Heater voltage at IC604 revealed low output (withref to pin 3) when problem occurred. Determined that prob |