Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | GDM17SE1 | SHUTS DOWN IN A FEW SECONDS | Unit shut down in a few seconds. 15v line not coming upenough to support operation. | ||
Sony | GDM17SE1 | NO PICTURE, NO HV, GEOM LIGHT IS ON | Unit has no high voltage. Geom light is on. Power Save andPower light are flashing. | ||
Sony | GDM17SE1 | NO PICTURE, ONLY POWER SAVE LIGHT ON | No picture. Has HV and Power Save Light is on. Unit workednormally when I changed the switch on back from 75 to 2K Ohm mode. I haveseen this problem many times for GDM17SE1 and GDM20SE1. | ||
Sony | GDM17SE1 | SCREEN SLOWLY DISAPPEARS CHECK C625 ON THE G-BOARD | The symptom of screen slowly diappearing was caused by C625failure. -HQ COMMENTS: Thank you. Please see Bulletin 70. | ||
Sony | GDM17SE1 | SHUTS DOWN IMMEDIATELLY. OPEN R639 (72V LINE) ON G-BOARD | At turn on the unit goes into shutdown, the power LED, powersaving LED, and geom LED are blinking. Found the 72V line inoperative.Replacing open R639 corrected the problem. -HQ COMMENTS: Thank you for the great symptom description. These typesof LED fa | ||
Sony | GDM17SE1 | PICTURE FADES AFTER A WHILE CAUSED BY FAILED C-625, G-BOARD | Monitor had normal picture for a few minutes then, faded outto none. If unit was allowed to cool down then re-powered, the sameoccurred. Checking Heater voltage at IC604 revealed low output (withref to pin 3) when problem occurred. Determined that prob | ||
Sony | GDM17SE1 | POWER ONLY, REPLACED PS502 FUSE | The unit was in the shut down mode but the centering and powersaving LED's were illuminated. | ||
Sony | GDM17SE1 | DIFFICULTY GETTING INTO ALIGNMENT MODES. | Had difficulty aligning 2 units. (S/N 2006095) originally hadproblem getting into all alignment modes, after reset only mode five wouldnot set. (S/N 2003131) had problems getting into all alignment modesbefore reset. After reset, mode 1 returned a mode | ||
Sony | GDM17SE1 | ACHIEVING WHITE BALANCE SPEC AT LOW LUMINANCE LEVELS | Ran through the entire White Balance adjustment using thelatest version DAS 5.0.1 and I'm having problems meeting thespecifications at low luminance levels. The DAS Screen states that x and ycolor coordinates should be within 8 but, Im getting 12 or grea | ||
Sony | GDM17SE1 | COLOR FLUTTERING FOLLOWED BY MISSING BLUE, REPLACE IC002 | Customer complaint was Waves going through display. At 1st theapparent problem was poor White Balance. After a while I noticed a reddishcloud fly by. Three days latter, the Blue color was missing permanently. | ||
Sony | GDM17SE1 | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
Sony | GDM17SE1 | RECOMMENDED SCREEN CLEANER | |||
Sony | GDM17SE1 | RECOMMENDED SCREEN CLEANER/USE (3-731-449-01) DRY SOFT CLOTH | This monitor has an anti-glare coating on the CRT. What typeof cleaner is recommended? -HQ COMMENTS: All GDM Monitors unlike CPD Monitors have a coating on thescreen surface. We recommend a dry soft cloth (P/N:3-731-449-01) to cleanthe screen surface. |