Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDTR31 | TAPE STUCK / REPLACE X403 | No tape movements EVF power on all the time, even inoffpposition, no date in evf or lanc, hold on remote. | ||
Sony | CCDTR31 | INDICATOR SHOWS THE BATTERY IS LOW/REPLACE C406 | Battery indicator shows as dead even with AC adaptor. Found schematic has mistake, pin. 57 of IC402 should be 3.0V insted of 0.3V. My reading was 1.3V. Capacitor C406 was leaky. | ||
Sony | CCDTR31 | J901 BREAKS LOOSE FROM DD48 BOARD | I have seen three units in the past 2 months where J901 brokeloose from the DD48 board. On older units, there used to be two screwssecuring the jack to the board, but on these, there are no screws. Theonly mechanical connection is between board and conta | ||
Sony | CCDTR31 | NO PLAYBACK VIDEO/REPLACE Q024 | No playback video, record OK, put into pause, distorted video. | ||
Sony | CCDTR31 | CAMERA E TO E FLICKERING/RESOLDER CN901 | Camera video flickers easily when camera is touched orslightly moved. | ||
Sony | CCDTR31 | NOISY PLAYBACK AS IF HEADS ARE CLOGGED/CHECK L160, VS BOARD | In VTR mode playback looks as if heads are clogged. Videocomes in and goes out etc. | ||
Sony | CCDTR31 | CAMERA "FLICKERING" CAM AND PLAY MODES/CHECK FP572 SOLDERING | Camera picture flickering in all modes. | ||
Sony | CCDTR31 | NO CHROMA FROM CAMERA/CHECK Q706, VC12 BOARD | Camera had no chroma just B/W picture. Also noticed tapeplayback had chroma interference lines but had chroma. Q706 on the VC-122board was not soldered into place. | ||
Sony | CCDTR31 | DISTORTED PLAYBACK VIDEO/RESOLDER L160, VS-95 | There was a distorted picture on playback. I found a properwaveform at pin 43 IC151 but there was nothing at pin 45 due to theabsence of PB 5V at Q025, Q026 and Q029. | ||
Sony | CCDTR31 | AVAILABILITY OF FP-443 BOARD | What is the part number for the FP-443 flex board? -HQ COMMENTS: This part is not available separately. It is supplied withthe LS Chassis Assy (X-3941-265-1). | ||
Sony | CCDTR31 | PLAYBACK IS SCRAMBLED/REPLACE UPPER DRUM | The unit displayed a very bad playback of self-recorded andpre-recorded picture. | ||
Sony | CCDTR31 | UNABLE TO ENTER VCR MODE/PAGE D ADD. 21 SHOULD BE 00 | After replacing VS-95 board I am unable to enter VCR mode orshut the unit off. Loading average data from the LANC jig allowed unit toreturn to normal operation. -HQ COMMENTS: There are addresses on page D that must be entered forcorrect operation of th | ||
Sony | CCDTR31 | SERVICE MANUAL ERRORS | Page 126 (AV-138 board) shows 3.6 vdc at pin 2 of IC602 andpage 108 (VS-95 board) shows 0.5 vdc at pin 13 of IC407. Which is thecorrect signal? -HQ COMMENTS: Correct voltages are as follows: IC602 pin 2: 0 Volts DC IC40 | ||
Sony | CCDTR31 | INTERMITTENT SOLARIZATION/IC-801, VC-122 | Camera has intermittent solarization ON/OFF. VTR mode is ok. | ||
Sony | CCDTR31 | NO VIDEO FROM CAMERA/L-160, VS-95 | Unit has audio in camera mode but no video out. |