Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81533
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | SL300 | EATS TAPE | Unit would thread as soon as power plugged in. Then wouldnot eject, but was trying to eject. If unloaded manually, then unitwould load tape normally but again would not eject. | ||
| Sony | CCDV99 | POOR AUDIO RECORD WITH LOUD POPS | Records audio poorly with loud pops during camera recordings | ||
| Sony | SPP100 | REPLACEMENT OF RINGER SPEAKER ON HANDSET | To obtain the ringer speaker (SP-201), it is necessary toorder the front cabinet because the speaker is not available separately. | ||
| Sony | KPR36XBR | DEAD UNIT WITH SLEEP LIGHT ON, COLD SOLDER ON L5008 | Unit appears dead. There is no Video or Audio but the sleeplight is on. Both the +12 volt and the +15 volt lines were down. | ||
| Sony | CPD1304 | VERTICAL PICTURE BOUNCING | Vertical picture bouncing (2-3 times/second). Finally, theraster may settle in a certain position. | ||
| Sony | CPD1302 | VERTICAL BOUNCING | Picture is unstable in all modes of operation. Also, the80 volt line measures high. | ||
| Sony | EVS900 | NO PLAYBACK OF PCM RECORDINGS | Unit will record PCM audio but will not play it back. LPPCM played back garbled. Video playback was ok. | ||
| Sony | KV27XBR10 | AUDIO DELAY, NORMAL | When the customer changes stations, the sound on his TV ismuted for an instant. Then, sound is heard on an external subwoofer amp-speaker connected to the VARIABLE OUTPUTS on the TV. After a delay, soundis heard coming out of the internal speakers on t | ||
| Sony | SPP90 | METAL PLATE ON THE BOTTOM OF THE HANDSET FALLS OFF | The plate is falling off the bottom of the handset whichsometimes results in the handset not charging. This situation occurswith our other phones as well. Can we use epoxy to reattach the plate? -HQ COMMENTS: Do not use epoxy to reattach the metal pla | ||
| Sony | KV27XBR10 | AUDIO MUTING, NORMAL USE VARIBLE OUTPUTS INSTEAD | Customer complains that muting does not work on an externalsubwoofer amp/speaker when the mute button on the TV is depressed. | ||
| Sony | GV9 | PART NUMBER | Need part number as soon as possible for the mode switch. -HQ COMMENTS: This is in the CCD-V99 service manual on page 179. Thepart number is 1-571-664-11. | ||
| Sony | GV8 | PART NUMBER | Need part number as soon as possible for the mode switch. -HQ COMMENTS: This is in the CCD-V99 service manual on page 179. Thepart number is 1-571-664-11. | ||
| Sony | SSU800AV | WRONG PART NUMBER LISTED FOR WOOFER | Part number 1-503-923-11 listed on service manual of speakerSSU-800AV for woofer (reference number 7) is not correct. | ||
| Sony | CFSW900 | NEW FF CAM GEAR DID NOT FIT | I tried to replace the FF cam gear, but the part that I got did not fit. -HQ COMMENTS: It appears that you received by mistake the REW CAM GEAR,part No 3-313-796-00. Please reorder. | ||
| Sony | KPR46CX10 | OPEN FILAMENT ON CRT, ARCING BETWEEN GROUND FINGERS & CRT | Servicer went to customer home and found green CRT had anopen filament, also Q606 was open. Replaced CRT and Q606 - set turned on,a minute later the filament opened and servicer saw arc but was not surewhere arc came from. Looked like it was from R726 |