Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | EVS900 | NO PICTURE IN PLAYBACK - REPLACE IC500 ON SP-7 BOARD | No picture in playback sometimes in pause picture would be ok. | ||
Sony | EVS900 | PLAY FOR A WHILE THEN SHUT DOWN M901 | Playback prerecorded tape for a while then, shuts off. Afterthat, you can not perform any function. You have to unplug the unit andput it back on, in order for unit to work again. | ||
Sony | EVS900 | NOISY PICTURE ON SOME PRERECORDED TAPES. VIDEO HEAD ASS'Y | On its own, the recording picture was OK. On some tapesrecorded on another machine there was one head dropout, on good tapes,both heads were OK. It is a strange problem. | ||
Sony | EVS900 | EJECT TAPE OR DOES NOT ACCEPT TAPE | Unit completes front loading process then ejects the tape. | ||
Sony | EVS900 | NO E-E AUDIO | No E-E audio. No video or audio when playing a tape. | ||
Sony | EVS900 | DEAD SET - NO FLUORESCENT DISPLAY | The unit will not power up. The fluorescent display was out.Fuses PS-104 and PS-102 were open. After replacing them, all unswitchedvoltages were normal except the back-up 5V at CN-106 pin 7 on the DT-63board. It read 2.8V. A check revealed that D-114 | ||
Sony | EVS900 | NO VIDEO ON PLAYBACK IN PCM/MIX POSITION | When playing back a pre-recorded tape with PCM and video rec-orded on it, the video and audio is ok in the (STD) position only. Whenswitching to the PCM or mix position, video is blanked to a white raster.Audio is still ok. I found that the MULTI PCM t | ||
Sony | EVS900 | PART NUMBER FOR SWITCH BLOCK, CONTROL. | When ordering the above mentioned part from our Kansas CityParts Center, the part number substitutes to 1-464-785-11, and the itemfor the EVS800 is received, with Japanese writing on it. -ACTION TAKEN: I checked WRPC, and found that 1-464-785-71 does | ||
Sony | EVS900U | SET SWITCH AUDIO MONITOR TO PCM MODE - VIDEO WAS MUTED | Customer complained that when setting front switch labeledAudio Monitor to PCM mode, the video information was muted, audio wasok. We found rear panel selector switch had to be set to Auto positionin order not to mute the video in playback mode. This c | ||
Sony | EVS900 | NO POWER | No power to unit at all - assembly clock display. Found F-103 (DT-63) board open. Replaced F-103 and powerwould only stay on for about 5-10 seconds, then shutdown. CN-201/4 wasonly about 1.5 volts.It should be 9volts. | ||
Sony | EVS900 | NO PLAYBACK OF PCM RECORDINGS | Unit will record PCM audio but will not play it back. LPPCM played back garbled. Video playback was ok. | ||
Sony | EVS900 | INTERMITTENTLY WILL NOT ACCEPT TAPE | Found that the unit would accept all tapes except P6-120s.Tape would intermittently hang up on left side. Tape did not fully loadonto reel assembly. | ||
Sony | EVS900 | CAN AUDIO BE DUBBED ON TAPE BEFORE VIDEO | Can an audio track be laid down before the video track? -HQ COMMENTS: No this cannot be done, the audio must be dubbed after thevideo. | ||
Sony | EVS900 | TAPE JAMMED NO FUNCTIONS | Tape jam no functions. |