Dicas Reparação
Modelo - Chassis CCDV1
Pesquisa: CCDV1 Enviar Dica Resolvida
Resultados 127
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV101 | DIGITAL TILTER PICTURE DISTORTED | Digital titler picture is distorted. Picture has black hor-izontal lines. If you turn the power off, then on immediately picture maylock on. | ||
| Sony | CCDV11 | FP-114 PART NUMBER | A part number is needed for the Flex Connector FP-114, 6-pin,that goes between CN-403 on the SS-82 board and W-901 on the mechachassis block (mode switch and dew sensor). See page 67, frame diagram ofservice manual. -HQ COMMENTS: Part number is 1-627-7 | ||
| Sony | CCDV101 | COLOR SHIFTS AND LINE IN PICTURE FROM CAMERA | Colors shift and changes to the right. | ||
| Sony | CCDV101 | PURPOSE OF (. 1 2) SWITCH | What is the purpose of the (. 1 2 ) switch? Customer recordeddistinctively different left and right information. During playback withthe switch in the 1 or 2 position he hears both left and right informa-tion. Please explain. | ||
| Sony | CCDV101 | DOES NOT RECORD | Camera will go to Record mode but on Playback only blackscreen. Found RF ok at TP-204 but no output on pin 27 or 22 going todrum. | ||
| Sony | CCDV110 | PART NUMBERS FOR BOARD TO BOARD CONNECTORS | A servicer needs the part numbers for CCD-V110 board to boardconnectors.Can you please give us part numbers for the following board to boardconnectors? VI-21 board CN201 to CC-6 board W901 (CV-9) VI-21 board CN209 to EM-1 board CN905 (VE- | ||
| Sony | CCDV110 | NO OUTPUT - UNIT DEAD | No output (unit dead) F-903 fuse blown. | ||
| Sony | CCDV101 | NO PLAYBACK RF | Traced problem to HR-10 board not receiving RP-5V on pin 7,however, had 5V on pin 19 (reg 5V) traced problem to L-236 open (236 wouldnot cause problem if the schematic were correct). | ||
| Sony | CCDV101 | VERTICAL LINES IN PICTURE | Vertical, winding lines in picture, unstable raster. | ||
| Sony | CCDV11 | NEW TYPE OF CONNECTORS | There are two types of connectors used for the CCDV11, crimp(old type) and insulation displacement (new type). -HQ COMMENTS: They are as follows:BOARD CN PIN CRIMP INSULATION DISPLACEMENTVC-32 611 4P 156554311 156675911 | ||
| Sony | CCDV101 | MECHANICAL NOISE WHEN THREADING OR UNTHREADING | Metallic rattling noise during eject or threading modes. | ||
| Sony | CCDV101 | CARRYING CASE FOR CCDV101 | What is the model number for the CCDV101 carrying case? | ||
| Sony | CCDV110 | NO VIDEO 5V FROM DC TO DC CONVERTER | No video 5V from DC to DC converter. This 5VDC line measuredabout 20 Ohm to ground. C-208 was shorted. | ||
| Sony | CCDV11 | BASE (1) GUIDE RAIL ASSEMBLY MISSING A GUIDE PIN | Picture rolling, looses vertical because tape tension is notnormal without the post that is shown on the picture attached. Founddifferent base (1) with and without the guide - needs assistance, to findpart number for guide missing, not shown on any serv | ||
| Sony | CCDV11 | DEW SENSOR ON | DEW sensor on. |