Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDV11 | WON'T LOAD/REPLACE C421 | Won't load, drum won't spin. | ||
Sony | CCDV11 | NO CROMA E TO E OPEN TRACE UNDER C661 ON VC32A BOARD | No chroma from camera head. Checked C663, found chromasignal. Q620 base no signal. Trace between the two components, runsunder C661. Removed C661 and found leakage to corroded trace. | ||
Sony | CCDV11 | CHROMA UNLOCK ON PLAYBACK | The chroma was unlocked on playback. This only occurred onself-recorded video, pre-recorded video was OK. | ||
Sony | CCDV11 | GUIDE ONE BASE ASSEMBLY REPLACEMENT PART DOES NOT FIT | Guide one base assembly does not fit properly. The inertialroller hit the side of the mechanism. | ||
Sony | CCDV11 | CAUTION LIGHT ALWAYS ON - INTERMITTENT VIDEO FROM CAM | Caution light always is on and camera video is intermittent.The VTR functions are ok. Records ok from camera when video available. | ||
Sony | CCDV11 | SCREW FOR BASE (3) ASSEMBLY, GUIDE RAIL | Refer to CCD-TR5 FPRs No. M0215 and K1192. The numberA-7040-154-A chassis block assembly mechanical is now substituted with a-P. When installing the old (Ref. No. 309) base (3) assembly guiderail, one of the two (Ref. No. 319) screws will have to be re | ||
Sony | CCDV110 | "DC" MARK IN DISPLAY | Service bulletin No. CAM0199 instructs tech to replace abovepart if the DC mark appears in display. 180899021 now crosses to180899041 which still containes the DC mark. -HQ COMMENTS: Tokyo advises that 1-808-990-21 will be stocked again inWRPC and avai | ||
Sony | CCDV11 | PART NUMBER FOR CAPSTAN MOTOR CONNECTOR | The service manual does not call out the connector for thecapstan motor as a separate part number and the FP-182 board does nothave the connector attached. -HQ COMMENTS: The part number for this connector is 1-565-662-11 andit is registered in KCP. | ||
Sony | CCDV11 | WON'T PLAY - SHUTS DOWN | Unit shuts down in Play, Fast Forward and Rewind modes. | ||
Sony | CCDV11 | LS CHASSIS CHANGE | According to service bulletin number CAM0144, the LS frame nowbeing supplied for the CCD-V11 is the above number. Servicer indicatesthat there is no way to install the old upper cabinet assembly on the newLS frame. Does the CCD-TR5 cabinet fit or can t | ||
Sony | CCDV110 | NO VIDEO ON CAMERA MODE | Recording a while, unit will record audio but no video oncamera mode. Noticed camera power is off, but still VTR is on. Performedbattery down adjustment and its the same. | ||
Sony | CCDV11 | CORRECT P/N FOR IC-401 | |||
Sony | CCDV11 | UNIT WILL NOT LOAD TAPE | Unit would not accept tape. Cassette housing would begin todesend-stop and then eject tape. Symptom was similar to bad reelsensors. Replaced sensors - same problem. Loaded tape manually withpower supply and pressed Play, drum took off and then shut d | ||
Sony | CCDV11 | FP-114 PART NUMBER | A part number is needed for the Flex Connector FP-114, 6-pin,that goes between CN-403 on the SS-82 board and W-901 on the mechachassis block (mode switch and dew sensor). See page 67, frame diagram ofservice manual. -HQ COMMENTS: Part number is 1-627-7 | ||
Sony | CCDV110 | PART NUMBERS FOR BOARD TO BOARD CONNECTORS | A servicer needs the part numbers for CCD-V110 board to boardconnectors.Can you please give us part numbers for the following board to boardconnectors? VI-21 board CN201 to CC-6 board W901 (CV-9) VI-21 board CN209 to EM-1 board CN905 (VE- |