Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDV101 | INT OR NO AUDIO/C562 LEAKS ONTO FEED OPENS CLOCK TO AU60 | Int or no audio, checked data lines into AU60 PCB. Found noSCK. Followed trace back and was open (int). Found leaky cap C562 overfeed through. | ||
Sony | CCDV101 | JAMMED MECH, NOISY AFTER REPAIR | The pin on the bottom of ref 353 is press-fit, and tends tocome loose. This causes it to disengage from the coaster spring, ref 356,and jam the mech. Putting a drop of super-glue on the pin and pressing itback in solves the problem. However, some of thes | ||
Sony | CCDV101 | TRANSPORT MOVES - NO EJECT/REPLACE CAPSTAN DRIVER IC | Unit would load & unload. Reels would not turn.Capstan would lock up in 1 position. Tried another motor by itself.Motor would start if it was spun up on eject. Motor would chatter thenstop. | ||
Sony | CCDV101 | JAPANESE CHARACTERS FOR MONTH ON OSD, LCD DISPLAY OK | Due to water damage, we had to replace the SS99 board on thisunit. After installation, we could not get the OSD to display the datecorrectly. Either it was yy/mm/dd or mm/dd/yy, but with the month inJapanese characters. | ||
Sony | CCDV101 | NO (LEFT CHANNEL) AUDIO/REPLACE C425, AU-60 BOARD | No audio in left channel from Mic or in P.B. or in VTR in Rec.Replaced HIC401. Same problem. Checked DC voltages and compared L toR. Found Pin 7 on HIC (VG-A) O volts, but is supposed to be 2.5. FoundC425 shorted to ground, holding voltage down. | ||
Sony | CCDV101 | DEAD/REPLACE C-799 AND FUSE F-103 | Found blown fuse F103 caused by a shorted C799 on VA45 boardcoordinates F19 on page 154 of service manual. | ||
Sony | CCDV101 | NOT RECORDING RF FOR HEAD 2/REPLACE Q202, VS99 BOARD | Unit will not record RF for channel 2 head. Replaced HR10board. Problem still persists. Traced the signal on HR10 board - Foundno output at Pin 37/IC101 - DC voltage 0.06V higher then pin 24/IC101 -Found Q202 (SS99 board) leaky base collector. | ||
Sony | CCDV101 | NO CASSETTE LOAD - EJECT WAS NORMAL | During Cassette Load, the drum would start but unit would notload and capstan would not turn. Using the cassette with the mode box, theunit would eject fine (load motor, capstan and drum would all run). Whentrying to load a tape while drum was running, t | ||
Sony | CCDV101 | MANUAL IRIS PROBLEMS WHEN THE BOARD IS REPLACED | After replacing the VC-67 board, the manual iris wouldfunction normally until the last point where the iris should be closed.At this point the iris would fully open. | ||
Sony | CCDV101 | ADJUSTMENT SCREW ON DRUM BASE ASSEMBLY | |||
Sony | CCDV101 | EXIT TAPE PATH ALIGNMENT CHANGED | Received refurbished unit with bad tracking at exit side.With tracking tape it looked good but when using Hi-8 tape - no good.There is a second adjustment screw for tilt of the Rt. coaster block. Howare we to align the tape path? The U mechanism adjust | ||
Sony | CCDV101 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-V101. The manual shows it aspart of the drum assembly. It is not included when ordering the drumassembly. -HQ COMMENTS: The partnumber is X-3686-482-5 and is in stock in KCP. | ||
Sony | CCDV101 | NO OPERATIONS - THOUGH IT POWERS UP | Power but no operations. Found that when disassembling andremoving ground wire between FD-15 board and camera block problem wouldclear up. Traced to key switch for color/mode had insulation damaged andwas shorting key scan to ground through the switch | ||
Sony | CCDV101 | PART NUMBER FOR COVER ASSY, GEAR | The above part number when entered in Kansas City and RPCdoes not register. Can you please check if this is the correct number? | ||
Sony | CCDV101 | P/N NOT IN S/M - FP262 CONNECTS FD-15, VC-67 AND FC-28 BOARD | Part number for above is not shown in the service manual.When part is bad, some technicians change the circuit board, not beingaware that this is available separately. |