Dicas Reparação




Modelo - Chassis


Pesquisa: Enviar Dica Resolvida
Resultados 81402
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCCDV101
DOES NOT RECORD Camera will go to Record mode but on Playback only blackscreen. Found RF ok at TP-204 but no output on pin 27 or 22 going todrum.
SonySTRGX50ES
PART NUMBER FOR IC-701 The part list in the service manual for IC-701 lists the partfor STR-GX60ES.
SonyWMAF57
VOLUME VERY LOW Volume very low.
SonyTAM50
WILL NOT RECORD MESSAGES After reset, may take one or two messages then will just shut-down.
SonyCCDTR5
NO CAMERA RECORD No camera Record. Line in Record ok. Viewfinder ok in cameraposition. Video out from camera to monitor ok - Playback ok.
SonyKV2095R
INTERMITTENT PICTURE BLANKING, LEAKY C-317 After unit warms up, picture would be blanked out and comeback ok at approximately one second intervals repeatively. Like ablinking effect.
SonyCCDV5000
COLOR FLICKERS 30 SECONDS INTO PLAYBACK Color starts flickering after about 30 seconds of playback.
SonyD66
CLV SUBSTITUTE PART - MOTOR LEADS TOO SHORT A-3133-372-A subs to A-3133-384-A. Original motor has eightinch leads. New motor has two inch leads.
SonyCCDTR6
NO COLOR RECORD Camera will not record in color - playback ok.
SonyGV300
IC-101 PART NUMBER 8-752-816-99 Correct part number 8-752-816-XX. Thirty in transit to KansasCity Parts.
SonyCCDM8U
NO RECORD COLOR No color recording from camera section.
SonyCDPC500
WIRE HARNESS IS TOO SHORT Regarding service bulletin HFP0127, part number 1-946-072-21yields an eight-pin harness about four inches long, whereas this unitrequires a harness about twelve inches long. -HQ COMMENTS: Will fax Tokyo. To Tokyo: Should harness be longer? Isthere a l
SonySL2000
VERY INTERMITTENT SHUTDOWN IN PLAY MODE In Play mode the unit will shutdown (go to Stop mode) veryintermittently.
SonyD10
STATIC ONLY IN AUDIO Static only in audio out.
SonyCDP310
STATIC WITH AUDIO Static in audio output.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads