Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP170 | HANDSET CUTS OFF | Handset suddenly goes dead because of ID TX design. When talkis pushed, handset cannot retrieve channel to line. This usually happenswhen handset is tapped, shaken or flexed. | ||
Sony | SPP120 | HANDSET CUTS OFF | Handset suddenly goes dead because of ID TX design. When talkis pushed, handset cannot retrieve channel to line. This usually happenswhen handset is tapped, shaken or flexed. | ||
Sony | SPP115 | HANDSET CUTS OFF | Handset suddenly goes dead because of ID TX design. When talkis pushed, handset cannot retrieve channel to line. This usually happenswhen handset is tapped, shaken or flexed. | ||
Sony | CCDTR4 | NO VIDEO ON EVF | No video from viewfinder. Open L-228 (broken) several unitswith this problem lately. | ||
Sony | D9 | SPINDLE PLATTER HEIGHT IS TOO HIGH | New motors coming from Kansas City Parts have the platterheight adjusted too high causing disk to rub. Ordered ten motors and somewere very high and some were slightly too high but all were unuseable.Motor was replaced because it was shorted and would n | ||
Sony | CDX5040 | DRAWS A LOT OF CURRENT, POWER AMPLIFIER BOARD DEFECTIVE | Draws a lot of current when unit is turned on. | ||
Sony | SLVR5UC | JAMMED MECHANISM | Damaged cam gear due to jam take-up side brake releaseassembly. | ||
Sony | CDPC85ES | NEW DISC TABLE FROM KCP HAS ONE HOLE PER DISC INSTEAD OF 2 | I ordered ref. No. 53 disc table (P/N 4-726-383-11) andreceived one with only one small hole and a slot instead of two holes. Ithen ordered No. 69, A-4604-533-A disc table assembly which included adisc table with two holes per disc. | ||
Sony | CDPC615 | UNIT WILL NOT READ DISC | Unit came in and would not read disc. No focus search. 7V B+missing from IC-102. | ||
Sony | TAE1000ESD | DC OFFSET ON FRONT OUTPUTS WHICH CAUSED AMP TO SHUT DOWN | Both front channels were offset from zero by about -2.1 volts.Amount of offset was the same within a couple of millivolts (Note that theschematic shows the emitters grounding the circuit the collectors weregrounded and the output was on the emitters). T | ||
Sony | XR7280 | AVAILABILITY OF MECHANISM DESCRIPTION VIDEOTAPE | Do we have a mechanism operation description? -HQ COMMENTS: The training dept. has produced a videotape whichdescribes the operation of the decks that are used in many different modelcar tape players. Fortunately, the deck that is used in the XR-7280 i | ||
Sony | KV2084R | LOSING VERTICAL DEFLECTION/VERTICAL FOLDOVER IS INTERMITTENT | On A board unit would have intermittent vertical foldoverand lose of vertical deflection. | ||
Sony | CDXA30RF | PART # ADDITION: PLUG HOLDER (PART OF REMOTE COMMANDER CORD) | The service manual is missing the part number for the plugholder at the end of the remote commander cord. | ||
Sony | CDX7580 | RECEIVING INCORRECT PART: L-401 68UH INDUCTOR | When L-401 is ordered, replacement from Kansas City will notfit. Original part is axial type in shape, while replacement is radialtype and will not fit under cross brace of main board. -HQ COMMENTS: The radial type inductor which you received from NPC | ||
Sony | CDX7560 | RECEIVING INCORRECT PART: L-401 68UH INDUCTOR | When L-401 is ordered, replacement from Kansas City will notfit. Original part is axial type in shape, while replacement is radialtype and will not fit under cross brace of main board. -HQ COMMENTS: The radial type inductor which you received from NPC |