Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | TAE1000ESD | REAR LEVEL LOW, INSUFFICIENT TO DRIVE AMP - FLASH HFP0040 | Customer is very dissatisfied with rear output level on hispre amp. I have verified that the rear channels are almost inaudible withall program materials. Customer owns following euqipment: TAE1000,TAN80ES, KEF10'S, FRONT SPEAKERS, CROWN PL4 W/KEF102 | ||
Sony | TAE1000ESD | NO AUDIO, ALL MODES - IC1001 FAULTY 8-759-146-52 | No audio in all modes. | ||
Sony | TAE1000ESD | AUDIO ONLY IN DOLBY SURROUND MODE - RESOLDER IC1001 | The audio will only pass in Dolby Surround mode, while theother modes are intermittently distorted. | ||
Sony | TAE1000ESD | CRACK ON ANALOG BOARD | Hair-line crack develops in area around mounting hole next toR902. This is a high-end product. I believe the (Design Group) needsextra effort with future products. This unit was purchased on January 11and it was received at the SSC on January 18th. | ||
Sony | TAE1000ESD | UNIT HAS NO DISPLAY | The unit has no display. AC and DC voltages supplied fromNo. 811 (T) on page 25 of the service manual are all present. Thefluorescent display FL-1001 was changed but problem still exists. -HQ COMMENTS: We have obtained information from Tokyo on the cl | ||
Sony | TAE1000ESD | DC OFFSET ON FRONT OUTPUTS WHICH CAUSED AMP TO SHUT DOWN | Both front channels were offset from zero by about -2.1 volts.Amount of offset was the same within a couple of millivolts (Note that theschematic shows the emitters grounding the circuit the collectors weregrounded and the output was on the emitters). T | ||
Sony | TAE1000ESD | NO AUDIO OUTPUT | Unit had no audio output unless it was in the Dolby Surroundmode. Data entered pin 10 of IC-506 but was not at the output (pin 11).Found by comparing to another unit that all digital audio originated frompin 11. IC-1001 and IC-506 had been previously r | ||
Sony | TAE1000ESD | UNABLE TO SELECT ANY INPUT EXCEPT TUNER | Only input available is a muffled tuner. You are able toselect different inputs with front panel controls. Panel shows new requestbut audio does not change. | ||
Sony | TAE1000ESD | NO VIDEO OUTPUT | Video 2 input works, but others do not. 2. Audio works fine. | ||
Sony | TAE1000ESD | UNIT WOULD NOT POWER UP | Unit would not power up. Found C-916 floating around looseinside of unit. Capacitor looked to be cut away from the Main board.Put a new capacitor in unit and the unit came up and ran. This is thesecond unit I have seen with this problem. -HQ COMMENTS: C | ||
Sony | TAE1000ESD | INTERMITTENT POPPING NOISE IN REAR SPEAKERS | Intermittent popping noise in rear speakers. | ||
Sony | TAE1000ESD | PART NUMBER FOR DISPLAY PCB WITH ALL COMPONENTS | We are trying to order a mounted display board with allcomponents. The service manual only lists a bare PCB. Is it possible toget a complete board? -HQ COMMENTS: According to KCPs information, you can't get a complete PCboard if the PC board has less | ||
Sony | TAE1000ESD | HUM WHEN USING SUBWOOFER AND CENTER CHANNEL OUTPUTS | 60 Hz hum heard at subwoofer speaker, when subwoofer amplifieris turned on to max volume out. | ||
Sony | TAE1000ESD | NO P/N LISTED FOR THE CAPS THAT COVER THE OPTICAL INPUTS | The small plastic covers that are inserted into the opticalinputs when they are not being used do not have a part number. They arenot shown on the exploded view, nor are they listed in the parts list.We have a customer that did not receive them with his | ||
Sony | TAE1000ESD | REMOTE COMPATIBILITY PROBLEM WITH STR-AV560 REMOTE | The customer has a TAE-1000 and a STR-AV560. He uses theSTR-AV560 for a tuner and a rear channel amplifier. When he selects tunerpresets with the STR-AV560 remote, the surround mode on the TAE-1000changes. Similarly, when changing surround modes with |