Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81447
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV1326R | HEADPHONE JACK, INCORRECT SUBSTITUE | Replacement part number 1-507-756-31 doesn't fit on board.Ordered new board (1-618-955-11) and it is the same as the old one. Needoriginal jack or good replacement or new board to fit this jack. -HQ COMMENTS: Earphone Jack 1-507-756-00 was incorrectly | ||
| Sony | CDPC900 | PART NUMBERS FOR BUSHING AND CLIP NOT REFERENCED IN S/M | Shaft 169 on page 27 of service manual fits through a smallplastic bushing that I've drawn in the accompanying service manual pageand the shaft is retained by a plastic clip that I've circled. No partnumbers. Servicer says that there was no grove at th | ||
| Sony | RME100 | USING THE RME-100 WITH NEWER UNITS | Will the 5 to 3 pin adapter cable 1-574-228-11 also power theRME-100? | ||
| Sony | CCDTR4 | UNLOADS VERY SLOWLY | Unit would unload very slow but load was ok. During unloadcycle 1/2 of normal voltage is on motor. | ||
| Sony | EVS900 | NO VIDEO ON PLAYBACK IN PCM/MIX POSITION | When playing back a pre-recorded tape with PCM and video rec-orded on it, the video and audio is ok in the (STD) position only. Whenswitching to the PCM or mix position, video is blanked to a white raster.Audio is still ok. I found that the MULTI PCM t | ||
| Sony | HST201 | BUZZING SOUND | Buzzing sound on all functions with the graphic equalizer con-trol to maximum and volume control to minimum. | ||
| Sony | TCFX420R | REPLACEMENT CAPSTAN MOTOR PROBLEM | The technician ordered the capstan motor (P/N 1-541-239-00)with number on the motor EG-500 AD-2B and received as a replacement (P/N1-541-745-11) with number on the motor EG-530AB-2B. The new motor has thenegative terminal connected internally to the shi | ||
| Sony | MHC3600 | ONLY TUNER WORKS WITH REMOTE CONTROL | None of the functions work with remote control except tuner.Manually all functions work normally. We found there was no SIRCS signalon pin 2 of IC-501 system control. Following the line, I found there wasthe correct waveform on CN-101 pin 11 input at t | ||
| Sony | TCDD3 | CAUTION INDICATOR REMAINS ILLUMINATED AFTER REPAIRS ARE MADE | When the Caution indicator was illuminated prior to repairsbeing made to this model, it remains illuminated even after the repair ismade. This leads the technician to believe that the unit still has aproblem. | ||
| Sony | GDM1936 | BUZZING WHEN SCREEN IS ON | When picture graphics appear on the screen, there is a buzz.The brighter the picture the louder the buzz. | ||
| Sony | KPR53CX35 | NO CONVERGENCE, REPLACED IC-5004 | No convergence. R-5151 opened, R-5152 overdissipatedand opened. Thus, no +15V or -15V to sub amps or sub-out transistors.R-5089 also overdissipated and opened. Q-5001 and Q-5002 checked ok.Resistors R5152 and R5089 were replaced but overdissipated and op | ||
| Sony | STRGX80ES | UNIT INOPERABLE AND VIDEO MONITOR LED ONLY IS ON | Unit is inoperable with no display, no sound and only videomonitor orange LED is on. | ||
| Sony | TCFX410R | NO AUDIO | No audio. | ||
| Sony | CCDF30 | CAPACITOR DRIES OUT | Varying symptom and intermittent. Picture is fuzzy like bador dirty V. head. Playback in slow mode (LP), like servo (ATF) problem.Sometimes when unit is cold, there is no picture. I've encountered thisproblem at least three times with PCB replacement. | ||
| Sony | TCW235 | UNIT WILL NOT GO TO SYNCRO DUBBING MODE | 1. Play on A deck, sound is muted. 2. Play on B deck, soundis ok. 3. Syncro dubbing mode, high or normal speed mode, B deck will notrun. IC-701, 702 and 703 had been replaced by SSC technician. |