Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP75 | NO TONE DIAL | Unit would not tone dial. Check for DTMF frequency at pin 18of IC-351. Found a single tone coming out of pin 18 instead of a mix oftwo tones to produce the number. | ||
Sony | KPR46EX32 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | KPR46EX30 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | KPR46DX10 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | KPR46CX50 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | KPR46CX35 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | KPR46CX25 | SPOTS ON CRTS, OPEN R-519 | Spot on the phosphor of all three CRTs. | ||
Sony | SPP75 | NO MUTE | When mute is pressed, audio is stopped from going out theline, but some audio is still heard in the handset speaker. Found pin 11of IC-601 was not going low. Traced line to pin 4 of IC-701 (microphonemute) and found the pin to be going low. Found pin | ||
Sony | STRGX67ES | UNIT GOES INTO PROTECT | No ground at CNP503 on the rear amp board. Traced ground tovolume board CN509, the ground at this point went nowhere. Alsopertains to serial number 809901. | ||
Sony | SLVR5UC | NO PLAYBACK VIDEO | No video when playing back a tape. Note: Video boards YC-92and YC-93 plug in together. The plug would not stay together just bypressing them back together. The boards had a slight bow causing them tointermittently come apart. The plugs are CN-41 and | ||
Sony | EVS3000 | EXCESS CHROMA NOISE AFTER TWO HOURS OR MORE PLAYBACK | Excessive chroma noise in Playback after approximately twohours. | ||
Sony | SLV595HF | DISTORTED ON SCREEN DISPLAY. PICTURE OK | On screen display is distorted and drifts horizontally. | ||
Sony | CCDSP7 | WRONG SCREWS FOR LAST FIVE MONTHS | Supplement No. 1 on page 2 No. 170 3-730-883-01 one of my ser-vicers has been trying to get the correct screws for five months now.Kansas City Parts has been called numerous times about this. I've calledTechnical Department to get this fixed. Yesterday | ||
Sony | STRGX99ES | LOW OUTPUT IN RIGHT CHANNEL | Unit has a low output in the right channel on all modes or nooutput on the Rear channel. This is the most typical problem with thismodel. | ||
Sony | CVPG700 | NOT PRINTING | When print function is activated, motors run but no mechanismmovement. Found that worm wheel (Ref. No. 163) would not engage to platenmotor (Ref. No. M-1401) due to burr on the worm wheel shaft. Because thisgear shaft is a component of the mechanism si |