Dicas Reparação




Modelo - Chassis STRGX99ES


Pesquisa: STRGX99ES Enviar Dica Resolvida
Resultados 8
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonySTRGX99ES
DISPLAY DIMS DURING LOUD VOLUME Customer complained that during loud bass, the display woulddim. I checked the +36v line and found that at loud volume, the voltagewould drop to 31 volts which is below the zener point. I did not wantto change resistor R783 (for safety reasons) to a lowe
SonySTRGX99ES
ON SCREEN DISPLAY PROBLEM - DISPLAY INDICATES FEATURE N/A When on screen on/off button is put on the display readsThis model does not offer this feature. -HQ COMMENTS: We were not able to obtain any additional information fromthe authorized servicer. The unit was returned to the dealer. We willconsider this
SonySTRGX99ES
FOUND ADDITIONAL IC ON A CLASS BOARD - IC710 Found additional IC mounted on A class board. Power amp wasnot shown in the service manual and need schematic to repair. IC islocated next to CNP764. IC type is Mitsubishi 5218A and package type is8-pin DIP. -HQ COMMENTS: 3/1/93 - We have FAX'd Tokyo
SonySTRGX99ES
PART NUMBER FOR RM-P321 REMOTE COMMANDER The part number for the remote commander RM-P321 is not shownin the service manual.
SonySTRGX99ES
NOISE WHEN CHANGING VOLUME - IC514, 8-759-801-01 On the center channel, as we increased the volume, the audiooutput was extremely noisy. It sounded like a dirty volume control. Ireplaced the volume control but it had the same problem. I found cleanaudio into pin 2 IC514. Pin 1 on IC514 had noisy au
SonySTRGX99ES
UNIT INTERMITTENTLY IN PROTECT MODE, BAD SOLDER ON "A" BOARD Unit would intermittently go into Protect mode. Found thatmoving class A PCB would cause this to happen. Second unit withproblem.
SonySTRGX99ES
NOISE IN SURROUND CHANNELS Complaint of noises in the surround channels when displaychanged. Verified that a short burst of static occurred when front panelfunctions were changed.
SonySTRGX99ES
LOW OUTPUT IN RIGHT CHANNEL Unit has a low output in the right channel on all modes or nooutput on the Rear channel. This is the most typical problem with thismodel.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads