Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDSP7 | NO VIDEO RECORD ON CAMERA IC365/VA40 BD | No record video - camera line input record on - play on. | ||
Sony | CCDSP7 | CHANGE IN CABINET, R, EVF. | Service manual ID's ref #166 as #A7080563A. Supplement -1shows modified #166, and part changed from #X37251221 to #X37251223.KCP subs original part # with latest part #. Servicer says it doesn'tfit. Apparently ref #152, also modified in supplement -1 | ||
Sony | CCDSP7 | NOISE IN VIDEO FROM CAMERA/REPLACE C405 | Noisy Video (vertical lines) in Cam mode. Checked signal(luminance) from Cam head section to checked okay, but video board atIC362 signal became noisey. Noise was in AGC circuit checked C405. | ||
Sony | CCDSP7 | PLAYBACK VIDEO IS DARK AND NO CHROMA/Q-397, VA-40 | Used block diagram on page 41. Checked signals on IC-360(CXA1200BX video process). IC-360 pin 20 demod out ok. Return to pin 23to low signal level and use schematic. Q-396 was not amplifying. Emitterwas 2.1V (spec 3.4V). Base was 0.565V (spec approxi | ||
Sony | CCDSP7 | WRONG SCREWS FOR LAST FIVE MONTHS | Supplement No. 1 on page 2 No. 170 3-730-883-01 one of my ser-vicers has been trying to get the correct screws for five months now.Kansas City Parts has been called numerous times about this. I've calledTechnical Department to get this fixed. Yesterday | ||
Sony | CCDSP7 | VIDEO ROLLS IN CAMERA MODE | Video rolls in viewfinder and monitor. | ||
Sony | CCDSP7 | NO VTR FUNCTIONS | Found no VTR functions after loading of tape. Unit doeseject and works fine in camera mode. Unit acts like it is in OFFposition. | ||
Sony | CCDSP7 | MOTOR NOISE PICKED UP BY MICROPHONE. | Customer complaint of motor noise in audio. Factory modon service bulletin #122 already installed. | ||
Sony | CCDSP7 | LINES IN PLAYBACK | Herring Bone in playback after a couple of minutes. Problemis present if self-recorded or pre-recorded tape used. | ||
Sony | CCDSP7 | NO SILL ADJUSTMENT | Service manual shows still adjustment pot RV-003. There is ahole in board for this adjustment but no adjustment pot is there. How doI adjust? -HQ COMMENTS: In playback pause, use edit search button on top ofcabinet to adjust for best pause. | ||
Sony | CCDSP7 | PART NUMBER FOR SOFT CASE | I need the part number for the complete soft case that comeswith the CCD-SP7. -HQ COMMENTS: The part number is A-7002-376-A. A service bulletin willbe issued. | ||
Sony | CCDSP7 | AFTER AWHILE PICTURE GETS LINES AND VF GOES BLANK | Picture became distorted after recording for 20-30 minutes.As if the camera was loosing sync and ACC control. | ||
Sony | CCDSP7 | LITHIUM BATTERY DRAINS TOO FAST | Lithium battery drains too fast. Q-203 on (SS-86) board isleaky, pulling down chip select line to IC-203. | ||
Sony | CCDSP7 | OWNERS MANUAL CORRECTION | There is an error on page 70 of the CCD-SP7 owners manual.The directions for macro are to press the telephoto button all the waywhile pressing the macro button. Actually, the wide angle button must bepressed instead of the telephoto. |