Dicas Reparação
Modelo - Chassis 1000
Pesquisa: 1000 Enviar Dica Resolvida
Resultados 340
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDTR1000 | OWNER'S MANUAL FOR CCD-TR1000/SAME AS CCD-TR101 | |||
| Sony | TADM1000ES | NO SIRCS OUTPUT ON VIDEO ONE - IC701 (P/N 8-759-152-23) | No SIRCS output to video one or video two but other SIRCSoutputs are fine. | ||
| Sony | TAE1000ESD | CRACK ON ANALOG BOARD | Hair-line crack develops in area around mounting hole next toR902. This is a high-end product. I believe the (Design Group) needsextra effort with future products. This unit was purchased on January 11and it was received at the SSC on January 18th. | ||
| Sony | TADM1000ES | CD1 SIRCS OUTPUT HAD NO CODE BEING OUTPUT | The CD1 4-pin SIRCS output jack had no signal coming out ofit. The Infrared emitter jack for CD1 also had no output. Other SIRCSoutputs were ok. | ||
| Sony | TADM1000ES | NO COMMUNICATION WITH REMOTE UNITS | Problem is communication with remote units (error light on). | ||
| Sony | TAE1000ESD | UNIT HAS NO DISPLAY | The unit has no display. AC and DC voltages supplied fromNo. 811 (T) on page 25 of the service manual are all present. Thefluorescent display FL-1001 was changed but problem still exists. -HQ COMMENTS: We have obtained information from Tokyo on the cl | ||
| Sony | TADM1000ES | UNIT GOES INTO ERROR | Unit would power up, receive switching signal and go intoerror. | ||
| Sony | ICB1000 | SERVICE MANUAL IS INCORRECT - REFERENCE NUMBERS 14 AND 15 | Illustrations on page 7 are wrong. No. 14 and 15 should bereversed. Then part numbers will be correct. -HQ COMMENTS: Thanks for the info. The descriptions vs part numbers inthe service manual are correct. But as you mentioned, the referencenumbers 1 | ||
| Sony | TAE1000ESD | DC OFFSET ON FRONT OUTPUTS WHICH CAUSED AMP TO SHUT DOWN | Both front channels were offset from zero by about -2.1 volts.Amount of offset was the same within a couple of millivolts (Note that theschematic shows the emitters grounding the circuit the collectors weregrounded and the output was on the emitters). T | ||
| Sony | DTC1000ES | REEL MOTOR BRAKE ASSEMBLY MALFUNCTIONS | If reel motor brake lever sticks to the reel table, the reelmotor will not work. To prevent this, replace the left and right brakelever assemblies which were not previously available separately.Part numbers are as follow: A-4910-211-A Brake Lever Asse | ||
| Sony | STRAV1000 | NO POWER | Unit was received inoperable. Upon checking IC-301, founddata pulses on pins 51, 52, 53 and 64 without any switches being pushed.GEQ Data and clock line always had data on them but I/O data did not. Myconclusion was IC-301 and IC-404 were not communica | ||
| Sony | TAE1000ESD | NO AUDIO OUTPUT | Unit had no audio output unless it was in the Dolby Surroundmode. Data entered pin 10 of IC-506 but was not at the output (pin 11).Found by comparing to another unit that all digital audio originated frompin 11. IC-1001 and IC-506 had been previously r | ||
| Sony | TAE1000ESD | UNABLE TO SELECT ANY INPUT EXCEPT TUNER | Only input available is a muffled tuner. You are able toselect different inputs with front panel controls. Panel shows new requestbut audio does not change. | ||
| Sony | DTC1000ES | TROUBLESHOOTING DIGITAL CIRCUITS | Intermittent audio distortion. Found that using a LeaderLB05860 waveform monitor hooked up to the digital output quickly demon-strated that one unit had a problem with its digital circuit and one didnot. Viewed the digital output on rear panel with the | ||
| Sony | TAE1000ESD | NO VIDEO OUTPUT | Video 2 input works, but others do not. 2. Audio works fine. |