Dicas Reparação
Modelo - Chassis DTC1000ES
Pesquisa: DTC1000ES Enviar Dica Resolvida
Resultados 5
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | DTC1000ES | BURST OF NOISE AT EDIT POINTS - ADJUSTED T/U TENSION | Unit fails to erase old material at edit points. If you RECORDPAUSE, then go back to record again, you will hear the old material forabout 1/2 second when you play back the tape. It appears that the tape isnot making adequate contact with the drum in the | ||
| Sony | DTC1000ES | REEL MOTOR BRAKE ASSEMBLY MALFUNCTIONS | If reel motor brake lever sticks to the reel table, the reelmotor will not work. To prevent this, replace the left and right brakelever assemblies which were not previously available separately.Part numbers are as follow: A-4910-211-A Brake Lever Asse | ||
| Sony | DTC1000ES | TROUBLESHOOTING DIGITAL CIRCUITS | Intermittent audio distortion. Found that using a LeaderLB05860 waveform monitor hooked up to the digital output quickly demon-strated that one unit had a problem with its digital circuit and one didnot. Viewed the digital output on rear panel with the | ||
| Sony | DTC1000ES | EATS TAPES | FF arm assembly very stiff movement causing slow return ofpinchroller to cassette when ejecting. The pinchroller is also veryglazed. | ||
| Sony | DTC1000ES | PRE-MATURE FAILURE OF PINCH ROLLER | Rubber pinch roller becomes dry and glazed after only 10-12months. Checked with owners to make sure they were not using head clean-ing fluid to clean rubber parts. In all cases the answer was no. Sampleis enclosed. -HQ COMMENTS: I will forward your s |