Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDFX410 | WILL NOT LOAD/UNLOAD | IC-510 appeared bad and it would not turn on Q-509. Put unitin page four address OE DATA 01 then Pause. Then address II DATA OC forUnload to troubleshoot IC-510. Had input to pin 14 and no output. Appliedsix volts on Q-509 collector and unit unloaded. | ||
Sony | TCFX170 | BAD MOTORS | Customer sent four TC-FX170's in for repair. All had badspots on motor. Also pertains to serial numbers 8814792, 8802009 and8801941. I've seen this at least five other times. | ||
Sony | CCDFX410 | CAPSTAN OVERSPEEDING | Capstan overspeeds. Mechanism will not operate. Apparentloss of F.G. | ||
Sony | CCDFX410 | AVAILABILTY OF FP-442 FLEX BOARD | We are getting many requests from the field for the partnumber for the FP-442 Flexible board. Is this part available? -HQ COMMENTS: This part is listed in the CCD-FX620 Service Manual page163. Part number is 1-641-639-13. | ||
Sony | CCDFX511 | NO VIDEO OUT IN PLAY | No video out. Scope pin 47 of IC-201 (video process) OIT.Trace through Q-216, 218, 220, 222, 223, C-260. Into IC-206 pin 1 VCAchip pin 3 had no output. | ||
Sony | CCDFX410 | WEAK LUMINANCE AND SYNC IN CAMERA VIDEO | Dark picture with loss of some horizontal sync. Picture doesnot roll luminance off the CS-31 board is ok. Checked luminance atC-071 into the capacitor is fine and out of the capacitor is weak withvery little sync. | ||
Sony | CCDFX310 | MULTIPLE LINES IN VIEWFINDER SCREEN | Multiple lines running horizontally in viewfinder screen.Upon examination of waveform at IC-501, pin 3, (vertical drive out) Ifound the following waveform: The irregularity occurred every threecycles. | ||
Sony | CCDFX411 | NO VTR FUNCTIONS/CAMERA OK | When put in the VTR mode, unit would shut off. Unit wouldturn on in VTR, viewfinder would light up, then 20 seconds later it wouldgo off. | ||
Sony | CCDFX510 | INTERMITTENT POWER | Unit would not always turn on with power switch. | ||
Sony | CCDFX410 | CAMERA VIDEO VERY DISTORTED/LINES IN PICTURE/RANDOM NOISE | Found pulses of IC-801 pins 30-335 distorted. Replaced IC-801from a scrap board with the same problem. Checked pulses pins 30-35still bad. | ||
Sony | WMFX70 | OVERSEAS MODEL - NEED PART NUMBER FOR THE REMOTE | Overseas model and the part number for the remote is not list-ed in the service manual. | ||
Sony | CCDFX410 | RED PICTURE FROM CAMERA | Unit played back pre-recorded tapes fine. Camera sectionwould output red picture with same video detail (looking solarized).Checked IC-802 A/D converter. There was no activity on pin 1 of IC-802 -0vdc. | ||
Sony | CCDFX510 | TAPE JAMMED | Technician Carl Smith reports symptom of tape jammed. The setwould sometimes work if tipped on its side. | ||
Sony | WMFX40 | AUDIO IS INTERMITTENT | Intermittent audio. | ||
Sony | CCDFX410 | JAMMED | Unit came in jammed. Gary Kilbourn found the cam gear hadseveral broken teeth. |