Dicas Reparação
Modelo - Chassis FS
Pesquisa: FS Enviar Dica Resolvida
Resultados 1630
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CFSW50 | MOTOR | This unit uses the same motors for both A and B decks whenordering we receive: 1-541-410-11/DNF8100A. Although they will physicallymount in place, we cannot get the speed correct. Also, the shaft on thereplacement is slightly smaller. -HQ COMMENTS: To | ||
| Sony | CFSDW60 | WRONG HEAD | Please note enclosed samples, we need the correct REC/PB headfor deck A. The stocked part is incorrect. Please advise. -HQ COMMENTS: Correct P/N is 1-543-406-11. We will issue a S/B. | ||
| Sony | CFS950 | FLYWHEEL SLOPE | Fingers on spring (thrust) are not strong enough to supportthe flywheel in position. Flywheel works back towards thrust plate so farthat its gear looses contact with take-up gears causing no take-up. | ||
| Sony | CFSW301 | REFERENCE NUMBERS MISSING PART NUMBERS | In preliminary manual, Page 2 Ref. 1, 2, 3 are missingpart numbers: REF P/N DESCRIPTION 1 A-3247-250-A Holder (R) Assy Cassette 2 A-3247-248-A Holder (L) Assy Cassette 3 A-3241-516-A Cabinet (Front) Sub Assy | ||
| Sony | CFS950 | INCORRECT PART NUMBER | Incorrect P/N: X-3322-501-1 and correct P/N: X-3322-548-11 -HQ COMMENTS: We have a S/B issued on this dated June 30, 1986 (TapeRecorder #209). The P/N on the S/B for the new detector is X-3322-540-1.This does work in CFS-950 as I have done a few myse | ||
| Sony | CFS700 | ANTENNA BASE TOO LARGE-TEMPORARY PARTS PROBLEM | The part of the antenna that fits into the case is too large. | ||
| Sony | CFSW440 | INOPERABLE PLAY BUTTON | Play button not working. | ||
| Sony | CFSW360 | EATS TAPES | Eats tapes. | ||
| Sony | CFS9000 | EXCESSIVE VOLUME AT LOW SETTINGS - AV POWER ONLY | With AC power there is excessive volume on low settings.Battery operation OK. Problem was excessive voltage on the 13.6V line.This line powers the output IC and when using AC power reads 39V. Checkedthe transformer output and found the red secondary le | ||
| Sony | CFSD7 | PART NUMBER FOR CONTROL BOARD | Looking for a part number for the control board (w/parts) ifthere is one available. -HQ COMMENTS: Mounted control PCB is no longer available. We can geta blank control PCB from RPC in Tokyo if you want one. Let us know. | ||
| Sony | CFSW360 | MISSING PART NUMBER | Need part number for AC line cord. | ||
| Sony | CFS400 | MOTOR | The above unit needs the motor. KC sents a sub which wasphysically bigger and rotates on different direction. We reorder the parton a different number (A-3133-251-A), still received different motor. | ||
| Sony | CFS4000 | DEAD | Unit will not power up. | ||
| Sony | CFS9000 | TRACKING NOISE IN AUDIO | When using the D-14 and the CFS-9000 on the same DC source,there is a noise in the audio that is equal to the tracking changes onthe D-14. The noise can be seen all over the D-14 including the ground,when the scope ground is connected to the DC supply g | ||
| Sony | CFS950 | DETECTOR BLOCK ASS'Y | When ordering P/N X-3322-501-1, it is subbed to P/NX-3322-540-1. Kansas City has done this twice when ordering P/NX-3322-501-1. I would like to know if the sub part is compatible or hasto be modified. -HQ COMMENTS: Yes, the new Detection Block Ass'y i |