Dicas Reparação
Modelo - Chassis CFSW50
Pesquisa: CFSW50 Enviar Dica Resolvida
Resultados 9
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CFSW504 | NO FAST FORWARD OR REWIND. | No Fast Forward or Rewind. The spring that pushes FF andRewind lever up, pops out of place. The spring is located under theflywheel.ref 219 FF Lever p/n 4-928-993-01.ref 220 REW Lever p/n 4-928-992-01. | ||
| Sony | CFSW501 | PULLEY ASSEMBLY MOTOR WON'T FIT | Unit had bad wow and flutter on (B) deck. Found problem to bebreaking pulley (which is plastic). The replacement is brass and will notgo into shaft of motor. | ||
| Sony | CFSW501 | FM NOT TUNING STANDARD 88-108MHZ BAND | After replacing IC-601 (controller) the set would not tune thestandard FM band. It tuned from approximately 65mHz-90.1MHz only. | ||
| Sony | CFSW504 | WRONG PART NUMBER FOR CABINET (REAR) | The manual has the wrong part number 3-362-587-01. | ||
| Sony | CFSW50 | (MD) BOARD | The (MD) board in this unit does not correspond to theschematic. Do we have any additional information? If so, please Fax tothe Minneapolis SSC. -HQ COMMENTS: We have no additional information on this at this time,and we have not had any other complai | ||
| Sony | CFSW501 | 10KHZ NOISE IN HIGH SPEED DUBBING | A 10KHz noise is heard only in high speed dubbing. All otherRecord, Playback functions ok. | ||
| Sony | CFSW501 | BATTERY LEAKING SHORTLY AFTER INSTALLATION | Battery is leaking, getting hot and going dead caused by theDC cut-off switch in the AC power plug. This causes DC from the powersupply to go into the batteries. | ||
| Sony | CFSW500 | BAD SOLDER JOB ON A.C. JACK | Poor soldering on A.C. jack resulting in no power from batter-ies or A.C. cord. If problem persists, should notify proper personnel.Same problem was found on serial number 111721. -HQ COMMENTS: Thank you for your information. We will inform Tokyo ofth | ||
| Sony | CFSW50 | MOTOR | This unit uses the same motors for both A and B decks whenordering we receive: 1-541-410-11/DNF8100A. Although they will physicallymount in place, we cannot get the speed correct. Also, the shaft on thereplacement is slightly smaller. -HQ COMMENTS: To |