Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDXA55RF | DISPLAY READS E04 (FOUND MOUNTING TAB FOR SENSOR MCB BENT) | Disc would not spin. | ||
Sony | CDXA55RF | WON'T READ DISCS (FOUND FLEX POORLY SOLDERED TO SLED MOTOR) | Flex cable coming from optic was not properly soldered fromfactory causing intermittent failure of optic to return to its inner mostpostion (HOME). This caused the symptom described as unit will loaddisc, but no spin, no play, no focus, intermittent. | ||
Sony | CDXA55 | PROPER ORIENTATION OF JACK FLEXIBLE BOARD | After disassembly of unit to check alignment, unit didnot work and WAIT appeared on controller. When power was applied, DRslider would cycle and when magazine installed elevator would move but notrespond to controls. | ||
Sony | CDXA55 | DAMPERS AND FLOATING CHASSIS DAMAGED DURING SHIPPING | Noticed all late model changers have been suffering damper &chassis damage during shipping. This is due to the fact that a method oflocking the floating mech was not included in the design. Noticed newmodels lack the same provision for reducing or eli | ||
Sony | CDXA55 | WILL NOT PLAY DISC | The disc is not clamped tightly against turntable causing thedisc to skip when trying to read TOC. The center of turntable is comingloose, preventing propper disc clamping. | ||
Sony | CDXA55 | JACK BOARD RECEIVED FROM NPC IS DIFFERENT FROM ORIGINAL | Received unit with broken jack board. Ordered (1-643-781-11).The computer subs to (1-643-781-13), but 1-643-781-14 is received, whichwill not work with this unit. Supplement 2 describes 2 jack boards, onewith copper through-holes and one with silver th | ||
Sony | CDXA55 | NO PLAY/NO EJECT (REPLACE DR GEAR REF. 112 P/N 3-364-432-01) | The unit would not load CD's. Also, it would not eject themagazine. The DR slider assembly moves freely. Found the gear (DR) wasbroken. | ||
Sony | CDXA55RF | "E-99" DISPLAYED, MAY ONLY PLAY DISC #1 | When play is pressed, E-99 will show up on display resettingunit does not help. Some units will play disc #1 and then flash E-99 whenany other disc is selected. Noted that right side of MD chassis was bentinto/over the X lever assy, jamming it and the | ||
Sony | CDXA55RF | NO LEFT CHANNEL (REPLACE JACK BOARD, P/N 1-643-781-11) | Unit had no left channel audio. Found that PCB trace betweenCNJ801 pin 12 and CN801 pin 9 open. It appears that the trace was notetched correctly at the factory. | ||
Sony | CDXA55 | UNIT JAMS, DISCS NOT RETURNED FULLY TO MAG. (REPLACE SW655) | Unit would load disc, but then when you went to change disc(for example: from 1 to 5) the slider assembly would not return previousdisc all the way in to magazine. Thus, when the elevator went up or down,the disc would hang up on the elevator assembly. | ||
Sony | CDXA55RF | UNIT JAMS, DISCS NOT RETURNED FULLY TO MAG. (REPLACE SW655) | Unit would load disc, but then when you went to change disc(for example: from 1 to 5) the slider assembly would not return previousdisc all the way in to magazine. Thus, when the elevator went up or down,the disc would hang up on the elevator assembly. | ||
Sony | CDXA55 | "E-99" DISPLAYED, SOMETIMES DOES NOT RETURN DISC TO MAGAZINE | During testing after installing service repair kit, unitwould sometimes not return disc to magazine before elevator moves to nextslot position. Noted that DR slider did not move back to center to pushdisc in pack. Disc would be bent up as elevator mov | ||
Sony | CDXA55 | MISSING PART # FOR FUSABLE LINK (ORDER P/N 1-532-686-21) | No part ref. # or part # listed in manual or supplements forIC901 fusable link. This link is not shown on the schematic or partsmounting diagram. It is found on the Jack board, and is marked N75J. DONOT CONFUSE THIS IC901 WITH THE VOLTAGE REGULATOR IC9 | ||
Sony | CDXA55 | SKIPPING WHEN VEHICLE MAKES TURNS (REPLACE OMD CHASSIS ASSY) | The CD player would skip only when the car would go aroundturns. The problem is caused by wobbling of the spindle motor. | ||
Sony | CDXA55RF | SKIPPING WHEN VEHICLE MAKES TURNS (REPLACE OMD CHASSIS ASSY) | The CD player would skip only when the car would go aroundturns. The problem is caused by wobbling of the spindle motor. |