Dicas Reparação
Modelo - Chassis CCDV11
Pesquisa: CCDV11 Enviar Dica Resolvida
Resultados 92
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV110 | NO OUTPUT - UNIT DEAD | No output (unit dead) F-903 fuse blown. | ||
| Sony | CCDV11 | NEW TYPE OF CONNECTORS | There are two types of connectors used for the CCDV11, crimp(old type) and insulation displacement (new type). -HQ COMMENTS: They are as follows:BOARD CN PIN CRIMP INSULATION DISPLACEMENTVC-32 611 4P 156554311 156675911 | ||
| Sony | CCDV110 | NO VIDEO 5V FROM DC TO DC CONVERTER | No video 5V from DC to DC converter. This 5VDC line measuredabout 20 Ohm to ground. C-208 was shorted. | ||
| Sony | CCDV11 | BASE (1) GUIDE RAIL ASSEMBLY MISSING A GUIDE PIN | Picture rolling, looses vertical because tape tension is notnormal without the post that is shown on the picture attached. Founddifferent base (1) with and without the guide - needs assistance, to findpart number for guide missing, not shown on any serv | ||
| Sony | CCDV11 | DEW SENSOR ON | DEW sensor on. | ||
| Sony | CCDV11 | QUICK REPAIR OF CCD-V11 LENS UNIT ASSEMBLY | Broken focus ring - zoom ok. | ||
| Sony | CCDV11 | TG-1 ARM FALLS OUT | Bushing that holds TG1 arm onto chassis falls out. Thechassis that would include this bushing is not supplied (see included copyfrom service manual). I am forwarding the arm and bushing just the way itwas found in the unit. Several CCD-V11s and CCD-TR | ||
| Sony | CCDV110 | UNIT SHUTS DOWN TRANSPORT | Transport would stop after a few seconds, also no reelcounter. Found no reel LED drive to sensors. Found C-302 shorted. | ||
| Sony | CCDV11 | CCD-V11 INTERMITTENT FAILURE IN CAM MODE | Itermittent or no camera power. | ||
| Sony | CCDV11 | CASSETTE EJECTS, BUT NEW CASSETTE CANNOT BE INSERTED | The cassette will eject properly, however, the loading motordoes not reverse the small amount needed to put the mechanism back in theloading/unloading mode after eject. Found cassette lock switch permanent-ly closed. After replacement, the same problem | ||
| Sony | CCDV11 | MOISTURE ON TAPE INDICATION | In the CCD-V11 owners manual on page 100 it refers to anemergency indication. Moisture present on tape surface. Is this right?How do we sense this? Maybe if the tape sticks to the drum we can monitordrum rotation? -HQ COMMENTS: There is no circuitry | ||
| Sony | CCDV11 | PART NUMBER FOR FLEX CONNECTOR | Do you have a part number for the 39 pin flexible connectorfrom the (SS-82) board to the (VA-37) board? -HQ COMMENTS: The part number is 1-574-125-11. | ||
| Sony | CCDV11 | WHAT MM RATING IS ON THE ZOOM RING EQUAL TO A 1:1 RATIO | On the CCD-V11 what mm rating is equal to a 1:1 ratio as com-pared to a 35mm camera? -HQ COMMENTS: At just shy of wide angle, the CCD-V11 is at a 1:1 ratiosince the 12 to 72mm focal length corresponds to F48 to 288mm converted to35mm. | ||
| Sony | CCDV110 | HARD CASE MODEL NUMBER | Is the LCV-812 the correct hard case for the CCD-V110? -HQ COMMENTS: Yes, the LCH-V200 may also be used. | ||
| Sony | CCDV11 | LS ASSEMBLY PART NUMBERS | Reference number 257 on page 150 is needed. Part numbers stopat No. 249. -HQ COMMENTS: Please refer to CCD-V11 service manual supplement No. 2. |