Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDTR400 | INT. DEAD, SHUT DOWN, LOCKUP (FOUND BAD SOLDER ON CN203) | An ASC reported that the unit had intermittent functions, orwould shutdown or lock up. Problem was found to be caused by poor solderon CN203. | ||
Sony | CCDTR40 | RECORDED AUDIO IS MUTED | Svcr. has unit that has muted mic audio. 5V is being appliedto pin 35 of IC601 (AU171 board). If you remove voltage audio is fine.Traced source of voltage back to pin 10 of IC158 (VS116 board). This isFADER OUT. Data comes through IC156 to control D/ | ||
Sony | CCDTR400 | DRUM SPINS FAST (FOUND X502 BAD) | Drum spins fast. | ||
Sony | CCDTR400 | BATTERY END ADJUSTMENT DATA ADDRESS IS INCORRECT IN S/M | When setting up to read data for battery end adjustment,value at address 47 does not change per procedure on page 7-62 of servicemanual. | ||
Sony | CCDTR400 | NO COLOR ON RECORD OR PLAYBACK / REPLACE X201 | Camera had no color through the monitor, but pix in EVF wasOK. Discovered frequency of VXO 40 Hz lower. | ||
Sony | CCDTR400 | SQUEAL USING MAXELL TAPE / | Had a few reports of the CCDTR400 producing a squeal,sometimes intermittently, from drum are which is actually caused by thetape. The offending tape is a Mexell Hi8 XR metal 100. Using any otheretape eliminates the noise. Suspect tape develops a bi | ||
Sony | CCDTR400 | INT B/W IN PLAYBACK / REPL IC201 (Y/C PROCESS) VS BOARD | Pix in playback has weak color and goes to b/w, then back toweak color. | ||
Sony | CCDTR400 | INDIVIDUAL MOTOR TESTING USING RM-95 | Models such as the CCDTR400 and CCDFX430 do not include themotor test on one of the service procedures, ex, capstan forward andreverse drum forward and reverse etc. | ||
Sony | CCDTR400 | UNIT PLAYS WITH NO TAPE INSIDE / RPL PS500 | Unit goes into play with no tape inside also does not sensereel rotation. Found PS500 open | ||
Sony | CCDTR400 | NO VIDEO FROM IO JACKS / CAB. KNOCKING PARTS OFF BOARD VS104 | No video from IO Jacko on camcorder. | ||
Sony | CCDTR400 | MOTORS NOT WORKING (LOADING, CAPSTAN) F451 OPEN / BAD CN901 | Motors not working (loading capstan) F451 open. | ||
Sony | CCDTR400 | BATTERY DOWN ADJUSTMENT - CORRECTION | The battery down adjustment in the manual is incorrect. -HQ COMMENTS: Working on a solution. | ||
Sony | CCDTR400 | NO LOADING, TAPE JAMMED IN UNIT REPLACE LOADING GEAR (B) | Unit had no loading or unloading. It came in with a tape jammed in it. | ||
Sony | CCDTR400 | POOR FOCUS/ADJUST FLANGE BACK | Poor focus. | ||
Sony | CCDTR400 | TAPE STUCK, NO FUNCTIONS, BEEPS WHEN TURNED ON/MODE SWITCH | Tape stuck, no functions, beeps when turned on. |