Dicas Reparação
Modelo - Chassis 21
Pesquisa: 21 Enviar Dica Resolvida
Resultados 8326
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDPC215 | VARIOUS PROBLEMS (RESET NOT WORKING) FLEX CABLE REF. 101 BAD | This unit would manifest a variety of odd problems, includingno play. Noticed that RESET on IC-202 was not going to 0V as required.It stayed at around 3V. Found a break in the ground lead of flexconnector between Main and BD board. This robbed the BD | ||
| Sony | CDPC211 | VARIOUS PROBLEMS (RESET NOT WORKING) FLEX CABLE REF. 101 BAD | This unit would manifest a variety of odd problems, includingno play. Noticed that RESET on IC-202 was not going to 0V as required.It stayed at around 3V. Found a break in the ground lead of flexconnector between Main and BD board. This robbed the BD | ||
| Sony | CDPC221 | NEWER UNITS HAVE DIFFERENT LOADING GEAR SCREW, 7-682-661-09 | Newer production units have a different screw for securing theA loading gear (ref. 112). The original screw is a step screw whichserves as the shaft for the gear the newer units have a machine screwwhich secures the gear to a brass post which is secured | ||
| Sony | CDPC211 | DISC TABLE ROTATES CONSTANTLY | Disc tray would rotate constantly when powered on. Could notopen or close tray. | ||
| Sony | CDPC215 | DISC TABLE ROTATES CONSTANTLY | Disc tray would rotate constantly when powered on. Could notopen or close tray. | ||
| Sony | SSM621AM | CONNECTOR P801 IS REVERSED, S/B # 46 HAS BEEN ISSUED | Connector P-801 on the Main board is reversed.Pin 1 should read Back GearPin 3 should read Battery -HQ COMMENTS: We have issued Security Products Service Bullein number 46using your information. | ||
| Sony | TAAV621 | AUDIO CUTS OUT, UNIT IN PROTECT - CHANGE R807 & R857 | I have several customer complaints regarding this problem.It occurs when in surround mode and the rear level is adjusted at 50% ormore. When the master volume is increased, unit goes into protect (relayopens). This problem occurs when in Simulated or Ha | ||
| Sony | CDPC221 | CD ONLY PLAYS FIRST 40 SECONDS, THEN REPEATS | CD would read TOC and play the first 40 seconds, then repeatitself. | ||
| Sony | HST221 | NO TAPE MOVEMENT - TAPE "A" LOST PINCH ROLLER X-3358-204-1 | Pinch roller shaft got loose from lever assembly. Thisresulted in the roller coming out. | ||
| Sony | TCW421 | DECK "A" EATS TAPE AND DOES NOT WORK PROPERLY - BELT 111 OFF | Belt A1 had come off pulley causing unit to eat tapes. | ||
| Sony | HST221 | UNIT INOPERABLE - IC701 SHORTED AND BLOWN FUSE F901 | Apparently IC-701 shorted and took out 6A fuse F901 in powersupply. | ||
| Sony | TAAV421 | MISSING PART NUMBERS: IC953 AND IC956, 8-759-604-32/-39 | We recently had an inquiry for p/n's for IC956 and IC953.After a great deal of searching, we finally found them in another s/m.The TA-AV421 s/m has many problems including missing pages, incorrectp/n's for reference no.s, p/n's missing, etc. Please chec | ||
| Sony | HST211 | SCHEMATIC ERROR: Q512 HIGH SPEED SWITCH | The schematic diagram indicates (page 11 of s/m) that the B+and B- supplies will be shorted if Q512 is activated to switch to the highspeed dub mode. This is obviously incorrect. Please notify Tokyo of theproblem so that a correction can be made to the | ||
| Sony | HST211 | INCORRECT PART: REF NO. 72 - BLOCK "A" | New buttons are physically different and not working in unit.Sent original and new buttons to Kansas City Parts for stock check. -HQ COMMENTS: This information was FAX'd to KCP (D. Ponder, P. Barnett)on 3/17/93. Waiting for info from KCP. -KCP REPLY: | ||
| Sony | TAAV421 | CD PLAYER ATTACHED CANNOT BE TURNED ON OR OFF | The associated CD player, CDP-221, could not be turned on oroff. Leaky Q-110 in the TA-AV421 was holding the CD control line in itsoff state. |