Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81406
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | TAH3600 | MECHANICAL BUZZ NOISE | A buzzing noise is audible from the set. | ||
| Sony | MHC3600 | MECHANICAL BUZZ NOISE | A buzzing noise is audible from the set. | ||
| Sony | XED75 | FRONT PANEL FROM NPC NOT COMPATIBLE UNLESS MODIFIED | The front panel received from NPC is not compatible with theXED-75 unless it is modified. The part includes 2 small rectangularplastic tabs along the bottom edge which prevent the panel from seatingproperly on the keyboard unit (ref. 901). The keyboard | ||
| Sony | CCDF56 | ERROR IN "VK-10" SCHEMATIC | The VK-10 schematic shows S-506 (time/next) switch is short-ed across the K out 4 line (W-502, 12). Obviously, this is incorrect.S-506 connects between K out 4 and K in 3 (W-502, 20) which it shares withS-510 (Record). S-512 (Frame) and S-508 (data scr | ||
| Sony | CCDF55 | ERROR IN "VK-10" SCHEMATIC | The VK-10 schematic shows S-506 (time/next) switch is short-ed across the K out 4 line (W-502, 12). Obviously, this is incorrect.S-506 connects between K out 4 and K in 3 (W-502, 20) which it shares withS-510 (Record). S-512 (Frame) and S-508 (data scr | ||
| Sony | TCFX120 | TECH TIP TO INSTALL NYLON WASHER IN FLYWHEEL ASSEMBLY | Nylon washer is easy to lose and difficult to install onflywheel shaft. | ||
| Sony | SLV373UC | NO POWER | Unit is completely dead. No unswitched voltages. Only vol-tage out of power supply is -7.9 volts for the -27.5 volts line. | ||
| Sony | WMD3 | UNCONTROLLABLE TAPE SPEED | Tape runs too fast. Cannot adjust tape speed. | ||
| Sony | SPP120 | NO OR INTERRMITENT AUDIO | Unit has no audio or intermittent audio. | ||
| Sony | STRAV1020 | TUNER BLEED THROUGH | Tuner bleed through while listening to another source (ie, CD,DAT, Phono, Tape). This is most noticeable during a quiet passage or be-tween tracks when the volume is at a high level. The problem appears tobe IC-606 and IC-607, the analog switch LC-7822 | ||
| Sony | SSU311 | PART NUMBERS FOR DRIVERS NOT AVAILABLE | The P/Ns for the drivers in this model are not available atthis time. | ||
| Sony | CCDF401 | LOW BATTERY ADJUST | I was informed by the technician in San Diego of a problem ofnot being able to do low battery adjust. The problem is if the unit isset higher than 5.58 VDC as called out in the procedure, the unit shutsoff and no display on the RM-95. This prevents you | ||
| Sony | CCDF201 | LOW BATTERY ADJUST | I was informed by the technician in San Diego of a problem ofnot being able to do low battery adjust. The problem is if the unit isset higher than 5.58 VDC as called out in the procedure, the unit shutsoff and no display on the RM-95. This prevents you | ||
| Sony | CCDF55 | LOW BATTERY ADJUST | I was informed by the technician in San Diego of a problem ofnot being able to do low battery adjust. The problem is if the unit isset higher than 5.58 VDC as called out in the procedure, the unit shutsoff and no display on the RM-95. This prevents you | ||
| Sony | KV27EXR15 | NO POWER WITH REMOTE, REPLACED Q-604 | Unable to activate power using the remote. I was able to getmomentary power on via the manual power button. Observed the voltage atbase of Q-601 the relay driver and it went to 1.2 volts then dropped to .4volts. The OVP line was low at 1.4V instead of |