Service Mode (Modo de Serviço)

HITACHI

D8MW

TV

Service Mode

Turn TV Off
Press and hold "MENU" key, press and release MASTER POWER BUTTON
Keep pressing "MENU" key until SERVICE MENU appears on screen

PANASONIC

LH88

TV

Service Mode

Press (VOL -) on TV then press (INFO) in remote 3 times in 2 seconds.

PHILIPS EMERSON MAGNAVOX

PL11.0

TV

Service Mode

1.Turn ON the Power.
2. Press MENU button to display Setup Menu.
3. Select FEATURES.
4. Select CURRENT SOFTWARE INFO.
5. Insert 0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.

SHARP

TV

Service Mode

1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the front of the receiver at the same time.
5. Keeping these buttons pressed, turn the mains on.
6. When the set starts up it will be in Service Mode. 7. Release the two buttons.
# Use the channel up and down buttons to move between the options.
# Use the volume control buttons to change the data.
# To store the data, use the stand-by button on the remote control.
# To exit the Service Mode, turn the receiver off using the mains switch.

SONY

AZ3F

TV

Service Mode

1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote within a second of each other: DISPLAY->Channel->5->Volume +
TV POWER

The first service menu (TV) displays More information in PDF

EMERSON

FL10.0

TV

Service Mode

1.Turn ON the Power.
2.Press MENU button to display Setup Menu.
3.Select FEATURES.
4.Select CURRENT SOFTWARE INFO.
5.0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.

SYLVANIA

FL10.0

TV

Service Mode

1.Turn ON the Power.
2.Press MENU button to display Setup Menu.
3.Select FEATURES.
4.Select CURRENT SOFTWARE INFO.
5.0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.

MAGNAVOX

FL10.0

TV

Service Mode

1.Turn ON the Power.
2.Press MENU button to display Setup Menu.
3.Select FEATURES.
4.Select CURRENT SOFTWARE INFO.
5.Insert 0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.

SONY

FIX2

TV

Service Mode

1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote within a second of each other: DISPLAY->Channel->5->Volume +
TV POWER

The first service menu (TV) displays More information in PDF

NOBLEX

TV

Service Mode

Pulsar rapidamente la siguiente secuencia en el C/R: Nº Canal, Pausa, Ap.Prog, Imagen Norm., aparecerán los menúes Factory1/2/3. Con CANAL+/- se modifica el menú Factory. Con VOL+/-, se ingresa a cada sub menú.