SE32JW73E01 Service Mode (Modo de Serviço)

SHARP

TV

Service Mode

1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the front of the receiver at the same time.
5. Keeping these buttons pressed, turn the mains on.
6. When the set starts up it will be in Service Mode. 7. Release the two buttons.
# Use the channel up and down buttons to move between the options.
# Use the volume control buttons to change the data.
# To store the data, use the stand-by button on the remote control.
# To exit the Service Mode, turn the receiver off using the mains switch.