Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | TCC5 | PART # CORRECTION FOR WIRE | The part # in manual is 153451700, This is incorrect. | ||
Sony | TCC5 | TRBLSHOOTING WITH MECH SECTION INSTALLED | Sometimes you would like to run the mech section withoutremoving it from the chassis, however this unit will not load without thecarousel installed. | ||
Sony | TCC5 | METHOD FOR CLEANING TCC5 PINCH ROLLERS | TCC5 pinch rollers can't be cleaned without disassemblingcassette tray and front panel. | ||
Sony | TCC521 | IC-833 AND BOARD MISSING | Unit would go into Play Pause. A second unit worked ok andhad an additional MCB with IC-833 on it. When this MCB was installed inthe two defective units, each worked normally. This IC or MCB is notshown in the service manual. -HQ COMMENTS: We will co | ||
Sony | TCC521 | WILL NOT COMPLETE LOAD CYCLE - S892 OUT OF POSITION | The unit would open and rotate normally but after closingdoor, the tape would stop before completing the loading cycle. Afterinspection, I found the metal actuator arm that is part of S892 hadslipped on top of plastic cam gear number 106. It can easily | ||
Sony | TCC5 | TRAY WILL NOT MOVE INTO PLAY POSITION - REPOSITION TRAY | Door closes but tray does not move into Play position. Fiveseconds later door will reopen. Door switch is good. | ||
Sony | TCC5 | DRUM WILL NOT LINE UP IN THE RIGHT POSITION, DRUM AND D891 | Drum will not line up in the right position. Spins and stopsbetween cassette holders then starts spinning again and stops betweencassette holders and so on. | ||
Sony | TCC5 | DOOR WILL NOT STAY CLOSED - REF 103 OUT OF POSITION | When you close the door, it will only close to the firstposition, the position where you can skip tapes with door closed. Afterfive seconds, the door reopens. | ||
Sony | TCC5 | IC-833 AND BOARD MISSING | Unit would go into Play Pause. A second unit worked ok andhad an additional MCB with IC-833 on it. When this MCB was installed inthe two defective units, each worked normally. This IC or MCB is notshown in the service manual. -HQ COMMENTS: We will co |