Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | TADL100 | NO FUNCTIONS - REPLACED PH701 | Unit has no functions. Functions CD1, CD2, tuner est willnot light up when pressed. -SOLUTION : PH701 is bad, pin on input signal was strong, pin 4 outputwas very low. Changed PH701. | ||
Sony | TADL100 | NO POWER - REPLACED POWER TRANSFORMER | No power. | ||
Sony | TADL100 | NO AUDIO - REINSERTED CNP903 | Unit had no audio. -SOLUTION : Connector CNP903 not plugged in. This connector suppliesvoltage to decoder board and main. | ||
Sony | TADL100 | FUNCTION LIGHT FLASHES - ADJUSTED RF | Function light on digital signal transfer box flashes andunit has no audio on functions that are flashing. | ||
Sony | TADL100 | NO AUDIO LEFT OR RIGHT CHANNEL -RESOLDERED SPEAKER TERMINAL | No audio out of left or right channel when testing unit withspeakers. RST found that speaker jack was cold soldered. | ||
Sony | TADL100 | NO AUDIO - IC109 FAULTY 8-759-604-29 | No audio output. RF is not transferred from TADM1000 toTADL100. | ||
Sony | TADL100 | NO CONTROL FROM REMOTE ROOM - COLD SOLDER ON CNS701 | No functions, keeps blinking, and does not accept commandsfrom the system. | ||
Sony | TADL100 | NO AUDIO/COMMUNICATION IS OK | No audio out of decoder board. EFM is ok. Found cold solderjoint on X-201 and case ground shield. | ||
Sony | TADL100 | DISTORTED AUDIO | Audio distorted, signal clipped. | ||
Sony | TADL100 | NO RMR INPUT | No RMR input control. I have two units with the same problem. | ||
Sony | TADL100 | LOSS OF LEFT CHANNEL | I have been informed by our Marketing Group that some unitshave been losing main left channel output. Pre-out works fine. | ||
Sony | TADL100 | INCORRECT LABELING OF ICS ON DECODER BOARD | The service manual has IC-203 as the clock oscillator(SN74HCU04) and IC-204 as the wave shaper (SN74HC00N), the physical boardhas IC-203 as wave shaper and 204 as oscillator. -HQ COMMENTS: Make the necessary changes in the manual. A servicebulletin wil |