Dicas Reparação




Modelo - Chassis STRD311


Pesquisa: STRD311 Enviar Dica Resolvida
Resultados 8
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonySTRD311
FAILURE OF RIGHT CHANNELS OUTPUTS - REPLACED C756 In a prior field problem report, I reported that the rightchannel was going out. We found Q755, Q762 and Q763 shorted. This unitis back for the 3rd time. Monitoring the voltage across R776, we foundthat after a few minutes it would start to rise. Wh
SonySTRD311
OUTPUTS FAIL - REPLACE PARTS AND HARDWIRE GROUND TO CHASSIS Outputs fail.
SonySTRD311
NO DISPLAY OR OUTPUT - TRANSFORMER OPEN Unit has no display, has power relay kick in, but primarytransformer open no power to unit at this point (open T901).
SonySTRD311
NO AUDIO OUTPUT - D955 SHORTED No audio. No -12v.
SonySTRD311
PROTECT ON - RECONNECT CNP404, CNP103 The unit is in protect. A visual inspection reveals that Join-1 board CNP404 is not connected with CNP103 on volume board.
SonySTRD311
LEFT CH OUTPUT CKT APPEARS TO FAIL MORE OFTEN THAN RIGHT My experience indicates that the left channel outputs onthese units fail far more often than the right. The only significantdifference I see is in the overload circuit, specifically Q714, which iswired differently for the left channel than the right.
SonySTRD311
WRONG Q712 IN UNIT - REPLACED WITH CORRECT PART Customer complained of unit never working correctly. Rightchannel looked OK, but, the NPN, Q712, in the left channel evidenced casedamage. Although most of the numbers were obscured by the damage, wecould see that it was a 2SC-----, not a 2SD2439, as i
SonySTRD311
Q706/756 (2SB2012) LEGS TOO SHORT The legs have to be cut on the old transistors and soldered tothe new transistors to have them reach the board. -HQ COMMENTS: KCP fax reply 04/14/94 According to KCP in checkingstock, the transistors lead length is 14mm from bottom of transistor(body) t


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads