Dicas Reparação




Modelo - Chassis STRD1011S


Pesquisa: STRD1011S Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonySTRD1011S
STATIC NOISE ON ALL FUNCTIONS - REPLACED IC404When using Dolby Pro Logic Modes unit had static noise soundslike bad reception on FM. Problem was heat related. Discovered defectiveIC404
SonySTRD1011S
LOW OUTPUT ON LEFT CHANNEL @ 300 HZ - NORMAL IN DANCE MODE When using video input 3 sound field dance mode, the outputat the left mainspeaker is approx. 30% lower than the right. To verifythe problem a generator was used at 300hz. Two other units with sameproblem. -HQ COMMENTS: Update 5/3/95: I checked the sa
SonySTRD1011S
NO POWER SWITCHED OUTLETS - REPAIRED BROKEN BD TRACES Lifted traces on power board no power output switchedoutlets.
SonySTRD1011S
INTERMITTENT POP LEFT CH, LEFT METER READS MAX - REPL IC404 After warm up there is a slight pop from left speaker. Leftside of Eq display will go max.
SonySTRD1011S
PROTECTION LIGHT ON - REPLACED IC601 AND IC602 Protection light on. -SOLUTION IC601 and 602 short out. Replaced two ICs and unit worked.
SonySTRD1011S
TOTALLY DEAD - IC203, RECEIVED MISLABELLED PART FROM KCP Tech at Circuit City called about this unit with no lights orpower up. Checked must-haves around IC203 and all were OK. Tech orderedand replaced IC203 no help. When I checked board I noticed suffix on ICwas -074 instead of -079. Bag and label were marked
SonySTRD1011S
DEAD MUTE LIGHT FLASHES - FRONT PANEL SWITCH STUCK CLOSED Found all start up power supplies good. Checked front panelswitchs, one was stuck in.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads