Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP80 | NO DIAL TONE - CRYSTAL X-503 REPLACED (P/N 1-567-994-11) | No dial tone. | ||
Sony | SPP80 | STATIC ON THE HANDSET | Bad reception. | ||
Sony | SPP80 | NO MICROPHONE AUDIO FROM BASE WHEN USING SPEAKERPHONE | Intermittent microphone audio output could be heard in handsetfrom base when using speakerphone by flexing PCB or hitting unit lightlyon top, but audio would soon be lost. | ||
Sony | SPP80 | MAG PLATE REPLACEMENTS | SPP-80 mag plate goes through battery front and back cabinet.If mag plate is installed while handset is together, it makes it verydifficult to open unit later on. | ||
Sony | SPP80 | INTERMITTENT AUDIO TRANSMIT FROM PORTABLE TO BASE | Intermittently will transmit audio from handset to base.RF waveform is present at handset's transmitter. Audio through IC-501 wasintermittent - very hard to troubleshoot. | ||
Sony | SPP80 | WHAT IS THE DISCONNECT TIME WHEN USING THE FLASH BUTTON | How long is the line disconnected for when using the flashbutton? -HQ COMMENTS: The line relay is opened for 500msec. | ||
Sony | SPP80 | MOTORBOATING NOISE IN HANDSET | Motorboating noise in handset speaker. | ||
Sony | SPP80 | CONSTANT BUZZ IN AUDIO | There is a constant buzz onto the speaker of the handsetas soon as the TALK button is pressed and the receiver is energized. | ||
Sony | SPP80 | AFTER GRABBING THE LINE, UNIT SHUTS DOWN AFTER A FEW SECONDS | When Talk button on Handset is pressed, Base unit and Handsetgo on-line normally. After about 30 secs., Base unit drops the line andHandset goes back to Standby mode. If Talk button is pressed again, samesituation occurs. Also applies to S/N 226939, 2 | ||
Sony | SPP80 | IMPEDANCE OF SONY TELEPHONE PRODUCTS | What is the impedance of our phone products? -HQ COMMENTS: All Sony phones fall in the range of 50 to 300 Ohms whenthe phone is off-hook and when DC-loop current is in the range of 15 -120 ma. | ||
Sony | SPP80 | BATTERY DOES NOT HOLD CHARGE | The battery was dead in the handset. Charged battery over-night. Unit functioned a couple of minutes the next day, then died.Replaced battery and charged overnight. Unit was functional for longerthan a few minutes, but went dead within one hour. | ||
Sony | SPP80 | METAL PLATE ON BOTTOM OF HANDSET FALLS OFF | The glue which holds the metal plate on the bottom of thehandset to the cabinet seems to be drying out. The plate is falling offthe handset. In some cases, the old plate can be reattached using epoxytype glue. In other cases, the original plate is los | ||
Sony | SPP80 | STATIC DURING CONVERSATION | Middle of conversation static could be heard and then cutoff.Intermittent in nature. Also applies to serial number 122135. | ||
Sony | SPP80 | HANDSET WAS DEAD | Battery ruptured. | ||
Sony | SPP80 | STATIC NOISE IN BATTERY SAVE MODE | Unit makes static noise from handset speaker during batterysave mode only. There is no noise in normal mode. This is the fifth unitI have seen with this problem. |