Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP150 | WON'T LOCK ON CHANNEL | Would not lock on channel. Checked and found frequency off.Tried to adjust CT-301 to no avail. When trying to adjust it, it seemedto skip over proper frequency. | ||
Sony | SPP150 | 10.24 MHZ CRYSTAL REPLACEMENT DOES NOT FIT | When ordering and inserting a new 10.24 Mhz crystal, the newcrystal does not fit in the handset. -HQ COMMENTS: The reason for this is that there were originally 2 sizes:a short one for the handset and a tall one for the base. However, theyboth have the | ||
Sony | SPP150 | UNIT WORKS O.K. IN NORM BUT DEAD IN BATT SAVE MODE. | Unit works fine in NORM mode, however no action in BATT SAVEmode when TALK is pressed. IC201/pins 12 and 29 went correctly from highto low when the mode switch was switched from NORM to BATT SAVE,indicating a good switch. IC201 was replaced to no avail. | ||
Sony | SPP150 | INTERMITTENT CHANNEL LOCK ON HANDSET | Intermittently the scanning of channels continues without itlocking on any channel. | ||
Sony | SPP150 | NO ACTIVATION DURING BATTERY SAVE | Unit works in normal mode but will not activate channelscanning in BATT SAVE mode. | ||
Sony | SPP150 | WHAT IS THE DISCONNECT TIME WHEN USING THE FLASH BUTTON | How long is the line disconnected for when using the flashbutton? -HQ COMMENTS: The line relay is opened for 500msec. | ||
Sony | SPP150 | NO CODE SENT TO HANDSET FROM BASE | Power light on Base continues to flash when Handset placed onBase. Handset is ok. Determined that code comes out of IC-501 pins 45 &46 then transmitted from Base to Handset over the air - not through topcharge terminals. When Handset placed on Base, c | ||
Sony | SPP150 | IMPEDANCE OF SONY TELEPHONE PRODUCTS | What is the impedance of our phone products? -HQ COMMENTS: All Sony phones fall in the range of 50 to 300 Ohms whenthe phone is off-hook and when DC-loop current is in the range of 15 -120 ma. | ||
Sony | SPP150 | SERVICE BULLETIN ERATA | Step one says to remove C552. This part does not exist in theunit. The diagram shown indicates C522 as the cap to be removed. Thispart does exist. Suggest a corrected CSA-12 Number 3 bulletin be issued. -HQ COMMENTS: The capacitor to be removed is C | ||
Sony | SPP150 | INTERCOM MODE OPERATION | Customer complains the intercom does not work properly.Instructions on page 19 of the instruction manual are not clear. Thehandset will ring once and lock a channel for 1 or 2 seconds. Whatshappening is the customer is going into the talk position afte | ||
Sony | SPP150 | HANDSET NOT RECEIVING I.D. CODE | Handset not receiving I.D. code when placed on base unit.Power LED on base continues to flash, no communication between handset andbase. By hard-wiring from where I.D. transmission exits (mini-chargeterminals) to where I.D. code enters handset, proved I |