Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SLV686HF | NO AUDIO OR VIDEO INSERT - NEED TO USE CXP50116-218Q IC | Circuit board being subbed over to A6721389B, which isfor model SLV585HF. After installing board there is no audio or videoinsert. | ||
Sony | SLV686HF | WRONT PT NUMBER FOR ROTARY SWITCH | Part number for rotary cam sw is wrong. Has flat connectorinstead of pins. | ||
Sony | SLV686HF | DEAD | Unit wouldn't power up. | ||
Sony | SLV686HF | POOR HI-FI AUDIO RECORDINGS: ADJUST RV801 RP112 BD | Would not properly record Hi-Fi audio. As a result of servicein another shop. The Y record current had been set too high. | ||
Sony | SLV686HF | SQUEEK IN FF AND RW REF309/PULLEY ASSY | Unit has a loud squeek in FF and RW. | ||
Sony | SLV686HF | INTERMITTENT STEREO IN SP PB: ADJUST RV401 PAGE 184 OF SM | Intermittently, the stereo display will flicker or go out andthe stereo or Hi-Fi will default to normal audio playback. The Hi-Fiplayback function is normal in the EP mode. On the pre-recorded tapes inthe SP mode, the Hi-Fi playback is also normal. | ||
Sony | SLV686HF | INTERMITTENT AUDIO ON LEFT CHANNEL: COLD SOLDER IC201 PIN23 | Intermittent audio from left channel. | ||
Sony | SLV686HF | DISTORTED AUDIO | Prerecorded tapes would playback fine. If you make arecording in SP and EP, the audio in the EP section would be distorted.The problem was occurring because part of part the RF envelope wasmissing. | ||
Sony | SLV686HF | NO SOUND AND UNSTABLE PICTURE FROM RF OUT WHEN COLD | Unstable audio on RF out until unit warms up. Line out signalis ok. | ||
Sony | SLV686HF | NO OUTPUT FROM TUNER E-E | No output from tuner, E-E. Channel indicator changesnormally. IC-001/pin 3 has output then it disappears as if unit is tryingto tune. IC-003/pin 7 (AFT Down) always High. IC-001/pin 16 (AFT Out)always at 0.6VDC. Unsolder IC-001/pin 16 (AFT Out) and |