Dicas Reparação




Modelo - Chassis SLHF550


Pesquisa: SLHF550 Enviar Dica Resolvida
Resultados 6
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonySLHF550
L-CH WILL NOT WORK PROPERLY ON BETA-HIFI 1. No L-CH on pre-recorded tape. 2. Distorted L-CH on self-recorded tape (and low level). This seems to be easy because you can com-pare with L-CH and R-CH. IC-1 had been changed by SSC technician. Check-ed DC voltage and waveform is same on L and R.
SonySLHF550
IC001 OVERHEATING Unit would shut down due to erratic 5V output from IC001 inthe power supply. Found that the aluminum heat sink for IC001 wasmissing from the unit.
SonySLHF550
VERTICAL JITTER AND ROLLING ON COPY GUARDED TAPES Vertical jumping and jitter when playing back prerecordedtape. -HQ COMMENTS: Problem is that copy guard changes the duty cycle of thetiming pulses in the vertical interval. Certain TVs and monitors are moreaffected than others. Older sets are more tol
SonySLHF550
AM PICTURE INTERFERENCE Customer located about 1/4 mile from AM transmitter operatingat 760 kHz. Signal is causing interference in picture during playback. -HQ COMMENTS: Try experimenting with a metal shield plate on top ofvideo drum ass
SonySLHF550
DANCING CHROMA NOISE Dancing chroma noise approx. 1 1/2 from bottom of screenon 27 monitor, problem only shows up on high grade tapes and is muchmore prevalent running to a video input. -HQ COMMENTS: The chroma noise is due to interference from the CTL headto the video trac
SonySLHF550
AUDIO LINE OUTPUTS LOW IN NORMAL E-E MODE The audio line outputs were down 15dB in the normal E-E mode.We found the problem to be caused by a defective IC501 on the SA-10 board.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads