Dicas Reparação
Modelo - Chassis MZ
Pesquisa: MZ Enviar Dica Resolvida
Resultados 96
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | MZ1 | INTERMITTENTLY WON'T ACCEPT MO DISCS (REPLACE REF. # 108) | When trying to load a recordable disk, the unit will eject thedisc immediately. It sometimes accepts disc with unit upside down. Foundpin 66 of IC-801 jumping high but not going back low as recordable discwas inserted. All three units loaded pre-recor | ||
| Sony | MZ1 | NO OPERATION (RESETTING IC801 RESTORED NORMAL OPERATION) | Unit is inoperative. All voltages look good. | ||
| Sony | MZ1 | DISPLAY DIMS DURING RECORD (REPLACE FB310, P/N 1-543-948-11) | Display would dim during Record. | ||
| Sony | MZ1 | DISC ERROR MESSAGE | Unit would not read TOC. The worm gear would not move becauseit was hung up on the optical block. | ||
| Sony | MZ1 | DISTORTION IN LEFT CHANNEL (IC-603 DEFECTIVE) | Distortion in left channel. After warm up, it became justnoise when I used the heat gun. | ||
| Sony | MZ1 | ADJUSTMENTS ARE NOT STABLE | After doing all adjustments and playing the unit for an hour,I would get intermittent audio (tracking or focus problem). | ||
| Sony | MZ1 | INOPERATIVE UNIT | Unit was inoperative and the fusible link PS401 was open.When I replaced the link and plugged in the unit, C5020 became physicallydamaged. | ||
| Sony | MZ2P | LOADING/UNLOADING DIFFICULTY, LOADING MOTOR M-703 DEFECTIVE | Disc was stuck inside unit. Once it was removed, the discwould load but it loaded a bit slow. | ||
| Sony | MZ1 | RESTORING UNUSABLE M/O DISCS TO USABLE CONDITION | The display shows UTOC ERROR when trying to read an M/Odisc. This problem may have been caused by the customer moving the unitwhile it was updating the UTOC area after recording. The owner's manualindicates that the disc must be replaced. | ||
| Sony | MZ1 | LOAD/EJECT VERY SLOW, MOTOR DRIVER IC-802 DEFECTIVE | Load/eject was very slow. | ||
| Sony | MZ1 | WILL NOT EJECT DISC (MECHANISM JAMMED BY DROPPING UNIT) | Disc was stuck in unit. I've seen this problem many times. | ||
| Sony | MZ1 | NO OPERATION W/ NICAD BATTERY, Q-401 (MAIN BOARD) DEFECTIVE | Unit would not power up when using the nicad battery. | ||
| Sony | MZ1 | DIGITAL NOISE IN AUDIO, CAUSED BY COLD SOLDERING OF IC-801 | Unit will intermittently put out strange digital sounds.These sounds are in both left and right channels. When I touched thesyscon IC-801, the sounds got worse. | ||
| Sony | MZ2P | DOES NOT WORK WITH AC ADAPTOR (FUSIBLE LINK PS-401 OPEN) | The unit does not operate when powered by the AC adaptor only.The unit works fine if the battery pack is installed and is chargedsufficiently, but the battery pack is not charging when the AC adaptor isplugged in. | ||
| Sony | MZ1 | TRACKING PROBLEM AFTER 2 HOURS, TRACKING GAIN MIS-ADJUSTED | After two hours of Play, unit had a hard time reading thedisc. You could hear the sled moving a lot more than normal. |