Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | MVCC1 | DISK PACK WILL NOT EJECT, ADJUSTED PLATE ASS'Y | Disk pack will not eject. | ||
Sony | MVCC1 | JAMMING OF DISK PACKS, REPLACED LOADING GEAR | Unit would jam while ejecting. | ||
Sony | MVCC1 | EJECT MOTOR RUNS FOR 1 SECOND THEN STOPS, REPLACE IC601 | When ejecting a disc pack, the eject motor would run for abouta second then all motion would cease. | ||
Sony | MVCC1 | SPINDLE MOTOR RUNS CONTINUOUSLY, REPLACED STEPPING MOTOR | Spindle motor runs continuously. | ||
Sony | MVCC1 | NO POWER, REPLACED D301 - D308 | Have seen diodes D301-D308 fail several times, more commonlygoing short circuit. -HQ COMMENTS: Thank you for the information. | ||
Sony | MVCC1 | INTERMITTENT OPERATION, REPLACED Q329 ON MA-1 BOARD | Intermittent operation of unit. | ||
Sony | MVCC1 | NO POWER, REPLACED Q310 ON MA-1 BOARD | No power. | ||
Sony | MVCC1 | WILL NOT ACCEPT THE DISK | Does X-212-382-51 item number 1 (holder assembly) include thecoil. | ||
Sony | MVCC1 | CUSTOMER NEEDS RF MODULATOR | Which RF modulator is the correct one for the MVC-C1?Customer also has only 300 Ohm input. -HQ COMMENTS: The RF-89 Ucka is the correct RF modulator but any of ourcurrent RF modulators for the handycams will work. There is a 300-75 Ohmadaptor in the RFU | ||
Sony | MVCC1 | PART NUMBER FOR BLANK DISKS | What is the part number for Mavica blank disks? -HQ COMMENTS: The part number is VFD-50. Every SSC should have disksfor repair on hand. |