Dicas Reparação




Modelo - Chassis KV32SXR10


Pesquisa: KV32SXR10 Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV32SXR10
INTERMITTENT RED FLASHES IN PICTURE, RE-SOLDERED IC301 Customer complaint of intermittent flashes of red in pictureset was sensitive to vibration or movement. -SOLUTION Located cracked solder connections on IC301 also NM301, andDl301 and numerous connector sockets. Resoldering corrected the problem.
SonyKV32SXR10
PICTURE OSCILLATES INTERMITTENTLY, REPLACED C1631 At high brightness levels picture would intermittentlyoscilllate/flutter. Problem was caused by C1631 in ABL circuit.Prevented correct ABL correction at high levels. Replacement resolvedproblem.
SonyKV32SXR10
INTERMITTENT LOSS OF VIDEO, RESOLDERED DELAY LINE Int loss of video or negative video.
SonyKV32SXR10
DARK PICTURE, RESOLDERED DL302 Picture becomes dark and red intermittently. During the lastsix months, I saw several cases like this. It also occurs on the KV25XBR. -SOLDER: After resoldering DL302, the set worked fine. -HQ COMMENTS: The Y signal is supplied from the Delay Line DL30
SonyKV32SXR10
BRIGHTNESS FLUCTUATION, REPLACE 12V REG IC-105 Brightness on picture tube would vary at a rapid rate, butvery slight. Scope shot of RGB signal to CRT at A-16 Connector revealedslight DC shift which was in phase with brightness changes. Further testsrevealed the following. The 12V line measured 11V
SonyKV32SXR10
TWO INCH BORDER AROUND PICTURE, LEAKY Q-1560 AND D-1502 Unit had a two inch border around picture.
SonyKV32SXR10
TIME CLOCK TOO FAST, SEE S/B 87R1, ADD CAPACITOR The time clock advances 12 minutes every hour. This indicatesthe microprocessor IC-101 is set to 50Hz. -HQ COMMENTS: Please refer to Service Bulletin number 87R1.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads