Dicas Reparação




Modelo - Chassis KV27XBR51


Pesquisa: KV27XBR51 Enviar Dica Resolvida
Resultados 9
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV27XBR51
GREEN FADES AWAY, ADJ GREEN CUT OFF Unit came on fine but after 30 sec the green would graduallyfade away. Picture was then comprised of red/blue. IK circuit did notblank RGB. Cooling jungle/IC301 restored operation for a minute butreplacement did not resolve problem.
SonyKV27XBR51
NO PICTURE OR SOUND, REPLACED D310 Power supply turned on and B+ voltages normal. Nohorizontal drive from IC301 p. 37 jungle, or vertical timing IC301 p. 28,29. Activity on the I2C bus momentarily when unit plugged in, but did notcontinue due to the lack of vertical timing back to the
SonyKV27XBR51
TIMER MODE MISOPERATION/ MISTAKE IN OWNERS MANUAL Customeris in the Video Mode. They set up the timer to turntheir TV ON at a preset time and channel. When the unit comes on thepicture is from the preset channel, but the audio is still in the videomode. -HQ COMMENTS: Customer Owners Manuals have a mist
SonyKV27XBR51
HOR. OUTPUT FAILURE, SEE SB 161R1 Dead Hor. Output Q-503 failed.
SonyKV27XBR51
NO VIDEO OR RASTER, RESOLDERED CONNECTOR B-29/PIN 22 No video or raster. Sound sometimes.
SonyKV27XBR51
STUCK IN VIDEO MODE, REPLACED IC701 (A BOARD) TV stuck in video mode.
SonyKV27XBR51
TIMER MODE MISOPERATION/ MISTAKE IN OWNERS MANUAL Customer is in the Video Mode. They set up the timer to turntheir TV ON at a preset time and channel. When the unit comes on thepicture is from the preset channel, but the audio is still in the videomode.-HQ COMMENTS: Customer Owners Manuals have a mist
SonyKV27XBR51
CLOCK RUNS FAST/ ADD CAP AS PER SB # 87R1 Clock gains time 2-12 minutes per hour. -HQ COMMENTS: Please refer to TV SB # 87R1, Fig 3, 27HFR etc.On the F-1 Board add a 0.1uf/50 volt capacitor between the base of Q-2601and ground. Part number for the cap. is 1-124-463-00.
SonyKV27XBR51
PURITY IS BAD/ COLD SOLDER LEAD ON THP-601 Found one leg of thermistor not soldered.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads